Administrator Guide

Table 66. Security
Setting Description
Password Encryption Algorithm Allows you to select the password encryption algorithm. From the
drop-down menu, select any of the following options:
• Base-64
• AES
• Plain-Text
The default value is Base-64.
Enable Gkey Reset By default, the Gkey reset feature is enabled. The factory reset of
the device can be performed when the G key is pressed during
device boot-up.
Install Certicates Allows you to select the certicate which you want to install on the
device.
From the drop-down menu, select the certicates which are added
in the le repository.
Enable SSH Allows you to enable Secure Shell (SSH) on the device.
Allow “root” SSH login Allows you to enable the root SSH login.
Enable VNC Server Allows you to enable the VNC Server.
Require User to enter password Allows you to set the VNC password.
VNC Password Allows you to enter the VNC password.
Prompt user on VNC session start Allows you to enable a popup message for accepting the incoming
VNC connection request.
Central conguration
Use this page to enter the le server, rmware server, root path, and the corresponding user credentials.
Table 67. Central
conguration
Setting Description
File Server Path Enter the full path of the folder that contains the wlx folder.
Supported protocols include ftp, http, and https.
The default protocol is ftp.
File Server Username Enter the user name to access the le server.
File Server Password Enter the password to access the le server.
Root Path This root path is used to access les on the server. The directory
name /wlx is appended to the root path entry before use. If root
path is not provided, /wyse is considered.
Firmware Server/ Path Enter the full path of folder that contains the rmware images.
Supported protocols include ftp, http, and https.
46 Managing group policies