Administrator Guide
Parameter Description
[Discover={yes, no}]
[SecurityMode={default, full, warning, low}]
3 DNS host name lookup "wdmserver"If WDMService=yes, set
DHCPinform=yes will do #1, set DNSLookup=yes will do #2 and #3.
If QuickMode is set to yes, the rapport agent will not block any other
process during ThinOS Lite boot up and increases the boot time of
ThinOS Lite.
If Discover=yes is specied, rapport discovers WDM server information
from the DHCP option tag, DNS service location record, and DNS host
name. If the WDM server is discovered, the WDM server UI is protected
on device. Default=yes.
NOTE: if "le server" is changed by WDM server, device will
reboot automatically to make sure all settings from WDM server
take eect. Default = yes.
SecurityMode species the SSL certication validation policy. If set to
default, it will apply SecurityPolicy setting.If set to full, the SSL
connection needs to verify server certicate. If it is untrusted, then drop
the connection.
If set to warning, the SSL connection needs to verify server certicate. If
it is untrusted, it's up to you to continue or drop the connection. If set to
low, the server certicate is not checked. The value is persistent, and the
default value of the setting is default. If the settings are factory default, or
if you are upgrading to ThinOS Lite 2.3 for the rst time, the value is
temporarily set to low. After loading any INI, it goes to Default.
WDMServer=<server_list>
[Retry=<retry number value>]
WDMServer — Species a list of IP addresses or DNS name, separated
by using a comma for the WDM servers. Once specied, it is saved in
non-volatile memory. [Intro build 2.0_013]
Retry — Determines the number of attempts to retry a contact to WDM
servers.
WINSServer=<server_list>
Species the WINS server address. The WINSserver is an IP list
separated by ";" or ",", with a maximum list size of 2.
TimeZone Parameter—Values
Using the TimeZone parameter, Table “TimeZone Parameter: Values” contains the zone value options that can be used.
For Example:
TimeZone="GMT - 08:00" ManualOverride=Yes Daylight=Yes \
Start=030207 End=110107 TimeZoneName=Pacific \
DaylightName=Pacific
Remember to use quotation marks (" ") since the option includes spaces. The example above uses the " \" to break a single continuous line
into multiple likes for easier reading with no" \" on the last line of the parameter.
220
Creating and Using xen.ini Files