Administrator Guide

If you clear the Mirror check box, the Span mode is enabled.
Blocks that are displayed on the screen represent the number of displays connected to the thin client. Each block
represents a single display screen.
Figure 41. Dual display setup
Every display contains a unique display order number and display configuration. You can move the blocks horizontally or
vertically and construct the multidisplay layout in mixed directions. To construct a new display layout, move the blocks
to your preferred position, and click Apply. A new display layout is created. However, when the block is moved to an
incorrect position, the system sets the block to its default position.
NOTE:
The Wyse 5070 Extended thin client supports up to six monitors. The Wyse 5470 Thin Client supports up to
three simultaneous displays.
● Select the Make this my main display check box to set the display as primary display or the main screen. After you set
the display as the main screen, the display block is highlighted in yellow, and the Make this my main display option is
disabled for that display block. The Make this my main display option is now available for other display blocks.
NOTE:
The Make this my main display option is effective only in Span Mode and always disabled in Mirror
Mode.
● Select the Disable current monitor check box if you want to disable a display.
If you want to enable the disabled display, from the Monitor drop-down list, select the disabled monitor, and clear the
Disable current monitor check box. Click the Test button and then click OK.
●
From the Orientation drop-down list, select an option to rotate the display screen in different directions.
● From the Resolution drop-down list, select a supported display resolution.
NOTE:
The default screen resolution on the Wyse 5470 Thin Client is 1366 x 768 or 1920 x 1080 depending on the
configuration. The default screen resolution on the Wyse 5470 All-in-One Thin Client is 1920 x 1080.
○ In Mirror Mode, the resolution list is derived from the intersection of resolutions in all connected displays.
○ In Span Mode, select a display block and change its resolution.
● From the Monitor drop-down list, select your preferred display.
3. Click Test.
The new display settings are applied, and you can preview the modified display.
4. Click OK to confirm the new settings.
Use the Identify option to know the display order number of the connected displays.
154
Configuring the thin client local settings