Setup Guide

Getting Started With Your System

1 Push the latch release buttons on the midpoints of the end piece to open the

rail latches (see Figure 1).

2 Align the end pieces of the rails on the vertical rack flanges to seat the pegs

in the bottom hole of the first U and the top hole of the second U.

NOTE: The rails can be used in both square-hole and round-hole

racks (see Figure 1).

Figure 1. Pushing the Latch Release Buttons

NOTE: To remove the rails, push the latch release button on the

midpoints of the end piece and unseat each rail.

3 Engage the end of the rails and release the latch release button to have the

latches locked in place.

4 On each vertical rack flange on the back, put two screw bases into the two

square holes right above the rail (see Figure 2).

5 Install the chassis stabilizer shipping brackets (optional) on the back

rack flanges.

6 Install and tighten the screws.

NOTE: To transport systems already installed in the rack, ensure

that the two chassis stabilizer shipping brackets (optional) are

in place.