Owners Manual

Figure 8. Removing and installing the front bezel

Installing the front bezel

1. Hook the right end of the bezel onto the chassis.

2. Fit the free end of the bezel onto the system.

3. Secure the bezel with the keylock.

Removing the system cover

Prerequisites

1. Follow the safety guidelines listed in the Safety instructions section.

2. If installed, remove the optional bezel. For more information, see the Removing the optional front

bezel section.

Steps

1. Rotate the latch release lock counter clockwise to the unlocked position.

2. Lift the latch toward the back of the system.

The system cover slides back and the tabs on the system cover disengage from the slots on the

chassis.

NOTE: The position of the latch may vary depending on the configuration of your system.

3. Hold the cover on both sides, and lift the cover away from the system.