Service Manual
Table Of Contents
- XPS 12 Service Manual
- Before working inside your tablet
- After working inside your tablet
- Removing the battery
- Replacing the battery
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the wireless card
- Replacing the wireless card
- Removing the front camera
- Replacing the front camera
- Removing the back camera
- Replacing the back camera
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the headset port
- Replacing the headset port
- Removing the microphone
- Replacing the microphone
- Removing the power-button board
- Replacing the power-button board
- Removing the volume-buttons board
- Replacing the volume-buttons board
- Removing the system board
- Replacing the system board
- Removing the back cover
- Replacing the back cover
- Removing the display assembly
- Replacing the display assembly
- Flashing the BIOS
- Getting help and contacting Dell
Removing the coin-cell
battery
WARNING: Before working inside your tablet, read the safety
information that shipped with your tablet and follow the steps in
Before working inside your tablet. After working inside your tablet,
follow the instructions in After working inside your tablet. For more
safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
CAUTION: Removing the coin-cell battery resets the BIOS setup
program’s settings to default. It is recommended that you note the
BIOS setup program’s settings before removing the coin-cell battery.
Prerequisites
Remove the battery.
Procedure
1 Lift the latch and disconnect the power-button board cable from the
power-button board.
2 Disconnect the coin-cell battery cable from the system board.
27