Service Manual

Next steps
1. Install the display assembly.
2. Install the M.2 2230 solid-state drive or the M.2 2280 solid-state drive.
3. Install the heat sink (for computers shipped with 11
th
Generation Intel Core i3-1115G4 processor).
NOTE: The system board can be removed or installed together with the heat sink attached. This simplifies the
procedure and avoids breaking the thermal bond between the system board and the heat sink.
4. Install the fans (for computers shipped with 11
th
Generation Intel Core i3-1115G4 processor).
5. Install the heat-sink and fan assembly (for computers shipped with 11
th
Generation Intel Core i5-1135G7 processor or 11
th
Generation Intel Core i7-1165G7 processor).
6. Install the battery.
7. Install the base cover.
8. Follow the procedure in After working inside your computer.
Status-light board
Removing the status-light board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The following image indicates the status-light board and provides a visual representation of the removal procedure.
Steps
1. Lift the latch and disconnect the status-light board cable from the keyboard-control daughterboard on the palm-rest and
keyboard assembly.
2. Using a plastic scribe, pry the status-light board by its right side.
3. Carefully peel the status-light board from the palm-rest and keyboard assembly.
40
Removing and installing components