Service Manual

Installing the status-light board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the status-light board and provides a visual representation of the installation procedure.
Steps
1. Place the status-light board into its slot on the palm-rest and keyboard assembly.
NOTE:
Ensure that the right side of the status-light board is aligned with the peg on the palm-rest and keyboard
assembly.
2. Connect the status-light board cable to the keyboard-control daughterboard on the palm-rest and keyboard assembly and
close the latch to secure the cable.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the display assembly.
5. Remove the system board.
Removing and installing components
41