Service Manual

Steps

1. Align the notch on the memory module with the tab on the memory-module slot.

2. Slide the memory module firmly at an angle, into the memory-module slot.

3. Press the memory module down until it clicks into place.

NOTE: If you do not hear the click, remove the memory module and reinstall it.

NOTE: Repeat step 1 to step 3 to install the other memory module if available on your computer.

Next steps

1. Install the base cover.

2. Follow the procedure in After working inside your computer.

Solid-state drive

Removing the solid-state drive1

Prerequisites

1. Follow the procedure in Before working inside your computer.

CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.

CAUTION: To avoid data loss, do not remove the solid-state drive while the computer is turned on or is in sleep state.

2. Remove the base cover.

About this task

The following image indicates the location of the solid-state drive1 and provides a visual representation of the removal procedure.

Removing and installing components