Service Manual

Steps

1. Peel the tape, and disconnect the speaker cable from the system board.

2. Peel the tapes that secure the speaker cable to the battery.

3. Remove the two screws (M2x2) that secure the speakers to the palm-rest and keyboard assembly.

4. Note the speaker cable routing, and remove the speaker cable from the routing guides on the palm-rest and keyboard assembly.

5. Lift the speakers, along with the cables, off the palm-rest and keyboard assembly.

Installing the speakers

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the speakers and provides a visual representation of the installation procedure.

Removing and installing components