Service Manual

Steps

1. Using the alignment posts and rubber grommets, place the speakers on the slots of the palm-rest and keyboard assembly.

2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.

3. Adhere the tapes that secure the speaker cable to the battery.

4. Replace the two screws (M2x2) that secures the speakers to the palm-rest and keyboard assembly.

5. Connect the speaker cable to the system board and adhere the tape that secures the speaker cable to the system board.

Next steps

1. Install the base cover.

2. Follow the procedure in After working inside your computer.

I/O board

Removing the I/O board

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Remove the base cover.

3. Remove the right fan.

About this task

The following image indicates the location of the I/O board and provides a visual representation of the removal procedure.

Removing and installing components