Service Manual

Steps

1. Place the I/O board on the palm-rest and keyboard assembly.

2. Align the screw hole on the USB Type-C port bracket with the screw hole on the system board.

3. Connect the screw (M2x4) that secures the USB Type-C port bracket to the system board.

NOTE:

Ensure to connect IO marked side of the I/O-board cable to the I/O daughter board and the side marked MB

to the system board.

4. Connect the I/O-board cable to the connector on the system board and I/O board.

Next steps

1. Install the right fan.

2. Install the base cover.

3. Follow the procedure in After working inside your computer.

Display assembly

Removing the display assembly

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Remove the base cover.

About this task

The following images indicate the location of the display assembly cable and display-assembly hinges and provide a visual representation of

the removal procedure.

Removing and installing components