Setup Guide

1. Align the screw holes on the system board with the screw holes on the palm-rest assembly.
2. Replace the five screws (M2x4) that secure the system board to the palm-rest assembly.
3. Adhere the tape and connect the touch-screen cable to the system board.
4. Connect the power-adapter port cable, speaker cable, keyboard-control board cable, touch-pad cable and fingerprint reader
to the system board.
5. Connect the display cable to the system board.
6. Align the screw hole on the display-cable bracket with the screw hole on the system board.
7. Replace the screw (M2x2) that secures the display-cable bracket to the system board.
Post-requisites
1. Replace the memory modules.
2. Replace the heat-sink assembly.
3. Replace the fans.
4. Replace the solid-state drive (half-length) or the solid-state drive (full-length).
5. Follow the procedure from step 3 to step 6 in “Replacing the hard drive”.
6. Replace the wireless card.
7. Replace the battery (half-length) or the battery (full-length).
8. Replace the base cover.
46
Replacing the system board