Service Manual

52 Display
18 Lift the display assembly off the computer base.
Replacing the Display Assembly
1 Follow the instructions in "Before You Begin" on page 9.
2 Place the display assembly in position and replace the four screws that
secure the display assembly to the computer base.
3 Route the display cable through the routing guides and connect the
display cable to the system-board connector.
4 Connect the digitizer board cable to the system-board connector.
5 Tighen the captive screw that secures the display grounding cable.
1 display assembly 2 screws (4)
3 display cable 4 top cover
5 antenna cables
1
2
5
3
4