Service Manual


1. Follow the procedures in Before You Begin.

2. Remove the CD/DVD drive, if installed (see Removing a CD/DVD Drive).

3. Remove the hard drive (see Removing a Hard Drive).

4. Disconnect the interface cable from the back of the Media Card Reader and from the Media Card Reader connector on the system board (see System
Board Components).

5. Pull up on the drive release latch and slide the Media Card Reader towards the back of the computer, then lift to remove the drive from the computer.

Installing a Media Card Reader

1. Follow the procedures in Before You Begin.

2. Remove the Media Card Reader from its packaging and ensure that all the screws are included.
1
interface cable
2
Media Card Reader connector
1
drive release latch
2
Media Card Reader
NOTE: If necessary, remove the Media Card Reader screws.