Service Manual



4. Attach the interface cable to the system board (see System Board Components).



5. Check all cable connections, and fold cables out of the way to avoid blocking the fan and cooling vents.



6. Replace the CD/DVD drive (see Installing a CD/DVD Drive).



7. Replace the computer cover (see Replacing the Computer Cover).



8. Connect your computer and devices to electrical outlets, and then turn them on.

See the documentation that came with the drive for instructions on installing any software required for drive operation.



9. Enter System Setup (see Entering System Setup), and then select the appropriate Drive option.

Media Card Reader

For information about using the Media Card Reader, see your Owner's Manual.



Removing a Media Card Reader

cable release tab

interface cable edge connector

interface cable

NOTICE: To connect a network cable, first plug the cable in to the network port or device, and then plug it in to the computer.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your

computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.