Service Manual


8. Rotate the front panel towards the computer until it snaps into place.

9. Replace the drive panel (see Replacing the Drive Panel).

10. Replace the computer cover (see Replacing the Computer Cover).

11. Connect your computer and devices to electrical outlets, and then turn them on.
Replacing the Rear LED Board

1. Follow the procedures in Before You Begin.

2. Remove the computer cover (see Replacing the Computer Cover).

3. Remove the system board (see Replacing the System Board).

4. Disconnect the REAR_LED_SENSOR cable from the master I/O board (see Master I/O Board Components).

5. Gently push the release tab away from the chassis to release the rear LED board and then slide it up and away from the computer.

6. To replace the rear LED board, connect the REAR_LED_SENSOR cable to the master I/O board (see Master I/O Board Components).

1
front panel
2
FRONT_LED cable
3
securing tabs (4)


1
release tab
2
rear LED board