Owners Manual

100 | Replacing the Camera Module
Replacing the Camera Module
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 11. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 13. For additional safety best practices
information, see the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Procedure
1 Align the tabs on the camera module with the slots on the camera assembly and
snap the camera module into place.
2 Connect the camera cable to the camera assembly and place the camera on the
display bezel.
3 Replace the screws that secure the camera assembly to the display bezel.
Postrequisites
1 Follow the instructions from step 3 to step 17 in "Replacing the Display Panel" on
page 96.
2 Replace the processor heat-sink fan. See "Replacing the Processor Heat-Sink Fan"
on page 52.
3 Replace the inner frame. See "Replacing the Inner Frame" on page 50.
4 Replace the system-board shield. See "Replacing the System-Board Shield" on
page 32.
5 Replace the I/O panel. See "Replacing the I/O Panel" on page 41.
6 Replace the stand. See "Replacing the Stand" on page 22.
7 Replace the trim cover. See "Replacing the Trim Cover" on page 20.
8 Replace the back cover. See "Replacing the Back Cover" on page 18.
9 Follow the instructions in "After Working Inside Your Computer" on page 13.
OM_Book.book Page 100 Wednesday, April 3, 2013 1:39 PM