Service Manual

46 System Setup
USB
Configuration
Allows you to enable or disable the USB controller.
Power
Power
Management
Setup
ACPI Suspend
Type
Specifies the ACPI suspend type. The default is S3.
Remote Wake Up Allows you to set the network interface controller to on or off.
This option allows the computer to turn on when a network
interface controller receives a wake up signal. The factory
default setting is Off.
Auto Power On Allows you to enable or disable an alarm to turn on the
computer automatically.
AC Recovery Specifies the behavior of the system after recovering from a
power loss.
• Power on — The computer turns on after it recovers from a
power failure.
• Power off — The computer remains turned off.
• Last state — The computer returns the power state it was in
before the power failure.
Device Detect
Error
Allows you to enable or disable the device error report.
Boot
Boot Device
Priority
Sets the boot priority among the available devices.
Hard Disk Boot
Priority
Sets the hard drive boot priority. The items displayed are
dynamically updated according to the hard drives detected.
CD/DVD Boot
Priority
Sets the optical drive boot priority. The items displayed are
dynamically updated according to the optical drives detected.
A5_bk0.book Page 46 Thursday, March 7, 2013 11:23 AM