Instructions / Assembly

INFORMATION ABOUT YOUR

READINGS

The meter will accumulate up to 100 readings. After all 100

readings are “stored” it will not add new readings until the

memory has been cleared. It will also continue to display the

average of all 100 readings as a reminder that the memory is full.

hTo add a reading to the sum of all the previously stored

readings, release the read button

! within 2 seconds.

When taking and storing readings of a specific material, be

sure to “clear” the meter before moving on to the next scale

if you do not want to group all of the readings together.

Readings below 6% will be displayed as -5.8 and readings above

40% will be displayed as a flashing 40.0. Neither of these types

of readings will be added to your accumulated readings.

TO CHECK ACCUMULATED

READINGS

This feature allows you to view the total number of all

accumulated readings for the given material you have chosen,

the average of those readings, and the highest stored reading.

hTo view the readings press and release the calibration

check button

@. First the meter displays the number of

accumulated readings for one second, then the average of

those readings for two seconds. Then it displays the highest

stored reading for two seconds. The total “cycle” time is

five seconds.

hTo erase readings hold the calibration check button

@ for

5 seconds. All accumulated readings will be erased and the

meter will display “0”.

hTo keep the accumulated readings in memory, release the

calibration check button

@ before the meter finishes the

above cycle.

TO RESET METER

hPress and release the calibration check button @.

hWithin one second press the scale button

hThe meter will reset itself the default setting of Scale #1

(wood) and 15% set-point, and clear all the readings stored

in memory.

hResetting the meter will erase any previously stored readings.