Specifications

14
Anchorage
clip
Anchorage
clip
I
I
V
V
INSTALLATION
■ Remove the burner as shown in figure 1.24.
■ Using a 7 mm box spanner, unscrew the injector (indicated by the arrow
in fig. 1.25) and replace it by the proper one according to the kind of
gas.
■ Then replace the burner and other components repeating the above steps
in reverse order.
IMPORTANT: Pay special attention to replace correctly the safety valve
probe "V" and the ignition electrode "I" as per figures 1.26 and 1.27.
Check the correct operation of the safety valve and the ignition electrode.
Figure 1.24
Figure 1.26
Figure 1.27
Figure 1.25