Specifications

49
A
B
S
F
C
T
BURNERS AND GRIDS
■ They can be removed and washed
only with soapy water. Detergents can
be used but must not be abrasive or
corrosive.
■ Do not use abrasive sponges or pads.
■ Do not put in dishwasher.
■ After each cleaning, make sure that
the burner-caps, as well as the
burners, have been well wiped off and
CORRECTLY POSITIONED.
■ Check that the electrode S (fig. 8.1) is
always clean to ensure trouble-free
sparking.
■ Check that the probe T (fig. 8.1) next
to each burner is always clean to
ensure correct operation of the safety
valves. Both the probe and ignition
plug must be very carefully cleaned.
Note: The electrode S must be very
carefully cleaned. To avoid damage
to the electric ignition do not use it
when the burners are not in place.
CORRECT REPLACEMENT
OF THE RAPID BURNERS
■ It is essential to check that the burner
flame distributor F and the cap C has
been correctly positioned (fig. 8.1-8.2)
- failure to do so can cause serious
problems.
CORRECT POSITION OF
TRIPLE RING BURNERS
■ The triple ring burner must be
correctly positioned (see fig. 8.3); the
burner rib must be fitted in their
housing as shown by the arrow.
■ The burner correctly positioned must
not rotate (fig. 8.4).
■ Then position the cap A and the ring
B (fig. 8.4 - 8.5).
CLEANING & MAINTENANCE
Figure 8.1 Figure 8.2
Figure 8.3
Figure 8.4
Figure 8.5