User guide

Installation Safety Precautions
Page 7Page 10
Using Your Beverage Cabinet
°C
°F
°F/
°C
The temperature range of this Beverage
Ÿ
Cabinet is 2ºC to 10ºC.
It is recommended you install the
Ÿ
Beverage Cabinet in a place where the
ambient temperature is between 23º-
26ºC/ 72º-78ºF. If the ambient
temperature is above or below
recommended temperatures, the
performance of the unit may be affected.
For example, placing your unit in extreme
cold or hot conditions may cause interior
temperatures to fluctuate and the range of
2ºC to 10ºC may not be reached.
You can select temperature display
Ÿ
setting from Fahrenheit to Celsius degree
by touching the ºF/ºC mark. Fahrenheit or
Celsius degrees indicator will appear in
green color in the temperature display
window.
ON/OFF Power
To turn the appliance ON or OFF, press
Ÿ
and hold the POWER button for 2
seconds.
To Lock the Control Panel
Your Beverage Cabinet is equipped with
Ÿ
an automatic Control panel lock function.
This function will prevent any unwanted
changes to your temperature or power
settings.
The lock function will activate
Ÿ
automatically 12 seconds after the last
time a button is pushed on the control
panel.
To unlock the control panel lock press and
Ÿ
hold the UP and DOWN arrow buttons
for 3 seconds the control panel will beep
and blink once indicating that the control
panel is active and the settings can be
changed.
Setting the Temperature Control
You can set the temperature as you desire
Ÿ
by touching the UP or DOWN arrow
buttons. When you touch the two buttons
for the first time, the LED readout will show
the original temperature set at previous
time (the temperature preset at the factory
is 2ºC to 10ºC).
The temperature that you desire to set will
Ÿ
increase 1ºF or 1ºC if you touch the UP
button once, on the contrary the
temperature will decrease 1ºF or 1ºC if you
touch the DOWN button once.
The temperature inside the unit will
Ÿ
appear in blue in the display window.
NOTE:
If the unit is unplugged, power lost, or
Ÿ
turned off, you must wait 3 to 5 minutes
before restarting the unit. If you attempt to
restart before this time delay, the
Beverage Cabinet will not start.
When you use the Beverage Cabinet for
Ÿ
the first time or restart the Beverage
Cabinet after having been shut off for a
long time, there could be a few degrees
variance between the temperature you
select and the one indicated on the LED
readout. This is normal and it is due to the
length of the activation time. Once the
Beverage Cabinet is running for a few
hours everything will be back to normal.
Electrical Connection
This appliance should be properly
Ÿ
grounded for your safety. The power cord
of this appliance is equipped with a three-
prong plug which mates with standard
three prong wall outlets to minimise the
possibility of electrical shock.
Do not under any circumstances cut or
Ÿ
remove the third ground prong from the
power cord supplied. For personal safety,
this appliance must be properly
grounded.
This appliance requires a standard 240
Ÿ
Volt AC ~/50Hz electrical ground outlet
with three-prong. Have the wall outlet and
circuit checked by a qualified electrician
to make sure the outlet is properly
grounded. When a standard 2-prong wall
outlet is encountered, it is your
responsibility and obligation to have it
replaced with a properly grounded 3-
prong wall outlet.
The cord should be secured behind the
Ÿ
appliance and not left exposed or
dangling to prevent accidental injury.
The appliance should always be plugged
Ÿ
into its own individual electrical outlet
which has a voltage rating that matches
the rating label on the appliance. This
provides the best performance and also
prevent overloading house wiring circuits
that could cause a fire hazard from
overheated. Never unplug the appliance
by pulling the power cord. Always grip
the plug firmly and pull straight out from
the receptacle. Repair or replace
immediately all power cords that have
become frayed or otherwise damaged.
Do not use a cord that shows cracks or
abrasion damage along its length or at
either end. When moving the appliance,
be careful not to damage the power cord.
Extension Cord
Because of potential safety hazards under
Ÿ
certain conditions, it is strongly
recommended that you do not use an
extension cord with this appliance.
However, if you must use an extension
cord it must be checked and tested by a
qualified technician or service person.
The extension cord must be a VDE-Listed,
3-wire grounding extension cord that has
a grounding plug and outlet and that the
electrical rating of the cord is 220-240
Volts and at least 10 amperes.