Instruction Manual

9
COOKING WITH LOW FUNCTION
1. Place the unit on a clean, dry counter.
2. Remove glass lid (L).
3. Fill the pot (I) with ingredients.
4. Replace lid.
From stand-by mode, turn the Function Selector Dial (A) to select
LOW function.
The lower display is switched o , Set Time/Temperature button (G)
is disabled.
The upper display defaults to h10:00m ashing, adjust cooking time
by turning Time/Temperature dial (C)
Turning clockwise the dial will increase the time by 15 minutes in-
crements, for a maximum set time of h24:00m.
Turning counterclockwise the dial will decrease the time in incre-
ments of 15 minutes , till h00:15m.
When adjusting the timer by turning Time/Temperature dial (C), the
display will stop ashing.
After 1 second that no selection is made, the display restarts ash-
ing.
Pressing Start/Stop button (D) the selected cooking function is
started , upper display will stop ashing, the red light (E) around
Start/Stop button will illuminate, cooking time begins.
If Start/Stop button (D) is not pressed within 20 seconds, the control
goes into stand-by mode.
It is possible to stop the function anytime by pressing Start/Stop
button (D).
The red light around Start/Stop button (E) will light o , the display
will turn to stand-by mode.
Once set time is elapsed , the control stops the function, the red
light (E) around Start/Stop button will turn o, the display will show
“End” ashing for 5 minutes.
While “End” is ashing you can reset the control by pressing Start/
Stop button (D).
The control goes into stand-by mode
If no further action is taken after 5 minutes of “End” ashing, the
control will automatically switch to Keep Warm function.
Keep Warm red light (F) will illuminate, the red light (E) around
Start/Stop button will light on , dots start ashing.
Once Keep Warm function timing is elapsed, the control will turn o
and will go into stand-by mode.
COOKING WITH MEDIUM FUNCTION
1. Place the unit on a clean, dry counter.
2. Remove glass lid (L).
3. Fill the pot (I) with ingredients.
4. Replace lid.
From stand-by mode, turn the Function Selector Dial (A) to select
MEDIUM function.
The lower display is switched o, Set Time/Temperature button (G)
is disabled.
The upper display defaults to h08:00m ashing, adjust cooking time
by turning Time/Temperature dial (C)
Turning clockwise the dial will increase the time by 15 minutes in-
crements, for a maximum set time of h16:00m.
Turning counterclockwise the dial will decrease the time by 15 min-
utes increments , till h00:15m.
When adjusting the timer by turning Time/Temperature dial (C), the
display will stop ashing.
After 1 second that no selection is made, the display restarts ash-
ing.
Pressing Start/Stop button (D) the selected cooking function is
started , upper display will stop ashing, the red light (E) around
Start/Stop button will illuminate, cooking time begins.
If Start/Stop button (D) is not pressed within 20 seconds, the control
goes into stand-by mode.
It is possible to stop the function anytime by pressing Start/Stop
button (D).
The red light around Start/Stop button (E) will light o, the display
will turn to stand-by mode.
Once set time is elapsed , the control stops the function, the red
light (E) around Start/Stop button will turn o, the display show
“End” ashing for 5 minutes.