User manual

9
Electrical connections
Before connecting the appliance to the power supply, check the following:
• The mains power supply must correspond to the power supply shown on the rating plate.
• The power socket and the electrical circuit must be adequate to supply the appliance.
• The power socket must match the plug. If not, have the plug replaced by qualified personnel.
• The power socket must be adequately earthed.
The manufacturer accepts no responsibility if these safety regulations are not complied with.
This appliance is manufactured in compliance with EEC directive EN 55014 relative to the suppression of
radio interference.
Description of the controls
Heating
pushbutton:
Switches heating
function on and off
Minimum speed/economy
heating pilot light:
Indicates appliance is operating
at minimum fan speed
Thermostat knob:
For setting temperature to
levels 1 - 5
Dehumidifying pilot light:
Indicates appliance in
dehumidifying function
Heating pilot light:
Indicates appliance in heating
function
Tank warning light:
Indicates the tank is full,
not in the correct
position or not fitted
Dehumidifying pushbutton:
Switches dehumidifying function
on and off
Humidostat knob:
Selects relative humidity
percentage from 1 to
continuous.
Maximum speed/maximum
heating pilot light:
Indicates appliance is operating at
maximum fan speed
Dehumidifier operation
1) Plug the appliance into a mains socket.
2) Check that the tank warning light is off.
3) Set the humidostat to its “CONTINUOUS” position (continuous operation).
4) Press the dehumidifying pushbutton. (The dehumidifying pilot light will come on and the appliance will start
operating. If the heating pilot light is on, press the heating pushbutton to switch the function off).
5) Select the maximum or minimum fan speed (the relevant pilot light will come on to indicate which speed
has been selected).
When the humidity in the room has reached the level desired, slowly turn the humidostat knob counter-
clockwise until the dehumidifying pilot light goes out. Your dehumidifier will then automatically keep the
humidity in the room at the selected level.
When in its dehumidifying function the appliance not only dehumidifies but also heats the room slightly.
Speed selection pushbutton:
Selects the ECON (economy heating) or
MAX (maximum heating) fan speed.