User's Manual

14
 FAST FLASHING
this means the “Home WLAN” has not been found
or has not been set.
“APP CONTROL” ICON
When the APP CONTROL icon appears
this means the last command was received via
Remote connection (e.g. APP).
If the saved “Home WLAN” setting needs to be changed, proceed
as follows:
1. Hold the
button pressed for about 20 seconds until
a long beep is heard;
2. Use the app to set the new “Home WLAN” settings in the
unit.
10. CLEANING AND MAINTENANCE
• Always disconnect the appliance from the mains before
carrying out cleaning operations (g. 13).
• Never submerge the appliance in water.
10.1 Cleaning the cabinet
• Never pour water directly over the appliance (g. 14).
• Never use petrol, alcohol or solvents.
• Never spray insecticides or similar substances as these may
deform the plastic.
• Clean the surfaces of the appliance using a soft cloth and do
not use abrasive sponges as these may scratch the surfaces
themselves (g. 15).
10.2 Cleaning the dust or silver ion lter
The frequency of cleaning will depend on the frequency of use:
if used daily, it is recommended to clean the lter every week.
• Remove the lter housing cover (A9) from the appliance
(g. 16).
• Extract the dust lter (g. 17).
• Remove any dust from the lter using a vacuum cleaner
(g. 18).
• If the dust lter is very dirty, rinse it well with warm water.
The water temperature must not exceed 40° C.
• Leave it to dry completely, then put it back into place.
10.3 Replacing the EPA lter
The appliance will automatically remind you when the EPA lter
(A7) needs to be replaced . After a preset number of operating
hours, the display shows the blinking symbol (C2) to indicate
that the lter needs to be replaced.
Always use original De’Longhi lters.
• Remove the lter housing cover (A9) (g. 16).
• Extract the used lter (g. 19) and replace it with a new
one.
• Close the lter housing cover (with the dust lter (A8)
inserted).
• Reset the lter alarm by holding the button (B2)
pressed for at least 10 seconds until you hear a long beep.
Please note:
the
symbol is intended only as a guide and it may be
necessary to replace the EPA lter more frequently, depending
on the air quality.
For long periods of downtime
• Disconnect the appliance from the mains and empty the
tank (A6).
• Clean the dust lter (A8) and re-insert it.
• Cover the appliance with a plastic bag to protect it from
dust.
11. TECHNICAL SPECIFICATIONS
Power supply voltage See rating plate
Input power “
Maximum input power “
Defrost device Yes
Hygrometer Yes
Fan speed 3
Air lter Yes
Frequency: 2400/2483.5 MHz
Maximum transmission power 10 mW
Operating limits:
Temperature 2°C - 30°C
Relative Humidity 30 - 90%