User Manual
Using Your Dishwasher
Page 9Page 24
Removable Hook and Loop strips are used to help
Ÿ
position the aesthetic wooden panel for fixing. Fit
the hook side of the strips to the back of the
aesthetic wooden panel.
Fit the loop side of the strips to the outer door of the
Ÿ
dishwasher so that the strips line up with each
other.
Press the wooden panel with hooks against the
Ÿ
dishwasher door. The hook and loops should hold
together. (See below).
Installation
Tension adjustment of the door
The door springs are set at the factory to the
Ÿ
proper tension for the outer door. If an aesthetic
fascia panel is installed, you will have to adjust the
door spring tension. Rotate the adjusting screw to
drive the adjustor to strain or relax the steel cable
(see below).
Adjust the door spring tension until the door
Ÿ
remains horizontal and balanced in the fully-
opened position, yet rises to a close with the slight
lift of a finger.
After positioning the panel, fix it to the door using
Ÿ
the screws supplied. Remove the four short
screws and screw in the four long screws.
FORGET TO ADD A DISH?
A forgotten dish can be added at any time before the
detergent cup opens.
1. Press the Start/Pause button.
2. Open the door a little to stop the washing.
3. After the spray arms stop working, you can open
the door completely.
4. Load the forgotten dishes.
5. Close the door.
6. Press the Start/Pause button, the dishwasher will
start running again after 10 seconds.
WARNING! It is dangerous to open the door
when washing, because the hot water may
scald you.
AT THE END OF THE WASH CYCLE
When the working cycle has finished, the buzzer of
the dishwasher will sound for 8 seconds, then stop.
Turn off the appliance using the Power switch button,
shut off the water supply and open the door of the
dishwasher. Wait for a few minutes before unloading
the dishwasher to avoid handling the dishes and
utensils while they are still hot and more susceptible
to breakage. They will also dry better.
Switch off the Dishwasher
1. Switch off the dishwasher by pressing the ON/OFF
button.
2. Turn off the water tap.
Open the door carefully
Hot dishes are sensitive to knocks. The dishes should
be allowed to cool down around 15 minutes before
removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a
few minutes before removing the dishes. Dishes will
be cooler and the drying will be improved.
Unloading the Dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one.
This will avoid water dripping from the upper Basket
onto the dishes in the lower one.
The program light is on but is not blinking, only in this
case the programme has ended.
Remove the 4 short screws
Screw in the
4 long screws
‘Hook’ Strip
‘Hook’ Strip
‘Loop’ Strips