Guide

ManualsBrandsDelonghi ManualsDishwashersFully-Integrated Dishwasher

Compartment A:

With each wash cycle.

Compartment B:

For prog rammes with pre-wash only.

(Follow the user instructions!)

Mechanical indicator C.

Electric indicator on control panel (if provided).

Check the rinse aid level

Load the baskets

Select a programme

Running the dishwasher

Switch off th e appliance

Tu r n o f f t h e w a t e r t a p ,

unload the baskets

Fill the detergent dispenser

Changing t he programme

Add forgotten dishes in the

dishwasher.

Scrape off any large amount of leftover food. Soften r emnants of burnt food in pans,

then load the baskets. Refe r to the dishwasher loading instructions.

If the appliance is switched

off during a wash cycle.

Open the door carefully.

Hot steam may escape

when the door is opened!

Switch on the appliance Open the door,pres s the On/Off button to switch on the appliance .

For detailed operating method read the corresponding content on t he instr uctio n manual.

Press the Me nue Button, then pre ss + or - Button select one progr ame, a t last press

OK b utton( See the secti on e nti tled Operation instruction )

 



Turn on the water tap ,close the door . The machine will start working after about 10 seconds.

1. A running cycle can only be modified if it has been running for a short time. Otherwise the detergent

may have already been released and the water already drained. If this is the case, the detergent

dispenser must be refilled.

2. Open the door,Press the Menue button .

3. Press + or - button select a new programe.

4. Press OK button ,close the door Restart the dishwasher.

󰍒󰍓 󰍒󰍓

1.Open the do or a little to stop the dishwasher.

2.After the spray arm s stop working, you can open t he door completely.

3.Add the forgotten dishes.

4.Close the door, the dishwasher will start running again after 10 seconds.

If the appliance is switched off during a wash cycle, when switched

on again, please re-select the washing cycle and operate the dishwasher

according to the original Power-on state.

When the work i ng cycle has finished, the buzzer of the

dishwasher will sound 8 times, dishwasher reverting automatically to

off-mode after the end of the programme .

Warning : wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid handling

the dishes and utensils while they are still hot and more susceptible to break.

They will also d ry better.Unload the appliance, starting from the lower basket.

Summary of content (26 pages)

PAGE 1
For detailed operating method read the corresponding content on the instruction manual. Switch on the appliance Fill the detergent dispenser Check the rinse aid level Load the baskets Select a programme Open the door,press the On/Off button to switch on the appliance . Compartment A: With each wash cycle. Compartment B: For programmes with pre-wash only. (Follow the user instructions!) C A B Mechanical indicator C. Electric indicator on control panel (if provided).
PAGE 2
Dear Customer, This appliance is in tended to be used in household and similar app lications such as: -staff kitch en areas in shop s, offices and other workin g en viron ments; -farm hous es; -by clients in hotels, motels and othe r residential type environments; -bed and breakfast type environments. Please carefully read this manual before using the dishwasher, it wil l help you to use and maintain the dishwasher properly. Keep it as a referen ce in the later da ys.
PAGE 3
CONTENTS Control Panel................................................................................................................................... ..... 2 Dishwasher Features.......................................................................................................................... ...2 A F ill the Rinse Aid Dispenser............. ..... ...................................................................................... .... ..3 B Function of Deterg ent ........ ....................
PAGE 4
When using your dishwasher, follow the precautions listed below: This appliance must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of an electric shock by providing a path of least resistance of electric current. This appliance is equipped with a cord having an equipmentgrounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with all local codes and ordinances.
PAGE 5
To get the best performance from your dishwasher, read all operating instructions before using it for the first time. 1.On/Off Button: To turn on/off the power supply. 2.Menu Button: Menu interface switch .Cycle selection: program selection delay time setting op tion setting alternative wash function selection language setting Pressing Menu, you can choose optional function and program 3.OK Button: Confirm the menu selected after pressing the button. 4. - Button: Move to the left.
PAGE 6
Before using your dishwas her for the first time: A. Fill th e rinse a id dispenser B. Fill in detergent Rinse Aid Dispenser The rinse aid is released during the final rinse to prevent water from forming droplets on your dishes, which can leave spots and streaks. It also improves drying by allowing water to roll off the dishes. Your dishwasher is designed to use liquid rinse aids. The rinse aid dispenser is located inside the door next to the detergent dispenser.
PAGE 7
Adjusting Rinse Aid Dispenser The rinse aid dispenser has six or four settings. Always start with the dispenser set on "4". If spots and poor drying are a pro ble m, increase the amount of rinse aid dispensed by removing the dispe nser lid and rotating the dial to "5". If the dishes are still not drying properly or are showing spots, adjust the dial to the next higher lever until your dishes are spot-free. The recommended setting is "4". (Factory value is "4".
PAGE 8
Amount of Detergent to Use If th e lid is close d: press rele ase button. The lid will spring ope n. Always add the dete rgent just before starting each wash cycle. Only use branded detergent and rinse aid for dishwasher. Dishwasher detergent is corrosive! Take care to keep it ou t of reach of c hildren. Proper Use of De terg ent Use only deterge nt specifically made for the use in dishwashers. Keep your detergent fresh and dry.
PAGE 9
Consider buying utensils which are identified as dishwasher-proof. Use a mild detergent that is described as 'kind to dishes'. If necessary, seek further information from the detergent manufacturers. For particular items, select a program with as low a temperature as possible. To prevent damage, do not take gla ss a nd c utlery out of the dishwasher immediately after the programme h as ended.
PAGE 10
The u pper basket is designed to hold more delicate and lighter dishware such as glasses, coffee and tea cups and saucers, as well as plates, small bowls and shallow pans (as long as they are not too dirty). Position the dishe s an d co okware so that they will not get moved by the spray of wate r. We suggest that you place large items and the most difficult to clea n items into the lower basket: such as pots, pans, lids, serving dishes and bowls, as shown in the figure below.
PAGE 11
( ) Means: need to fill rinse into the Rinse-Aid Dispenser. Auto sensing wash, lightly, commonly or heavily soiled crockery, with or with out dried-on food For heaviest soiled crocker y, and soiled pots pans dishes etc with dried on soiling. For heavily soiled loads, such as pots, plates, glasses and lig htly soiled pan s. (*AS/ NZS 2007 .1) Standard daily cycle for normally soiled loads, such as pots plates glasses. For lightly soiled c rockery and glass.
PAGE 12
5 Press the menue Button ,then press - o r + button change the program as follows direction: Auto->Intensive->Heavy->No rmal->Glass-> 60 Min ->Rapid->Soak; If a program is selected, th e display screen will show. P ress the OK button,Close the door, the dishwashe r begins to start. Premise: A cycle that is underway can on ly be modified if it has only been running for a short time. Otherwise, the detergent may have already be en released, a nd the appliance may have already drained the wash water.
PAGE 13
The filter prevents larger remnants of food or other objects from getting inside the pump. The residues may block the filter, in this case they must be removed. The filter system consists of a coarse filter,a flat (Main filter) And a microfilter(Fine filter). Main filter 2 1 Fo od and soil particles trap ped in this filter are pulverized by a specia l jet on the lower spray arm and washed down to drain.
PAGE 14
Remarks: - Inspect the filters for blo cking a fter e very time the dishwa sher has been used. - By unscrewing the coarse filter, you can remove the filter system. Re move any foo d remna nts and clean the filters under running water. The entire filter assembly should be cleaned once a week. Cleaning the Filter To clean the coarse filter and the fine filter, use a c leaning b rush.
PAGE 15
After Every Wash When not in Use for a LongTime After every wash, turn off the water supply to the appliance and leave the door slightly open so that moisture and odours are not trapped inside. It is recommend that you run a was h cy cle with the dishwasher empty an d the n remove the plug from the socket, turn off the wa ter supply and leave the door of the appliance slightly open. This will help the d oor seals to last longer and prevent odours from forming within the appliance.
PAGE 16
Please carefully read the installation instruction. Illustrations of cabinet dimen sions and installa tion position of the dishwasher 1 2 Preparations should b e made befo re moving the dishwasher to the installation place. Choose a place near the sink to facilita te the installation of inlet and drain hoses (see figure 1). If dishwa sher is installed at the corner o f the cabinet, there should be some sp ace (illustrated in figure 2) when the door is opened.
PAGE 17
2 Install the hook on the aesthet ic wooden panel and put the hook into the slot of the outer door of dishwasher(see figure 4a). Af ter positioning of the panel , fix the panel onto the outer door by screws and bolts(See figure 4b) . Figure4a Installation of aesthetic panel Figure4b Installation of aesthetic wooden panel 1 . take away the four short screws 2 .
PAGE 18
Tension adjustment of the door spring The door springs are set at the factory to the proper tension for the outer door. If aesthetic wooden panel are installed, you will have to adjust the door spring tension. Rotate the adjusting screw to drive the adjustor to strain or relax the steel cable (see figure 5). Door spring tension is correct when the door remains horizontal in the fully opened position yet rises to a close with the slight lift of a finger.
PAGE 19
PAGE 20
Dishwasher must be level for proper dish rack operation and wash performance. 1 Place a spirit level on door and rack track inside the tub as shown to check that the dishwasher is level. 2 level the dishwasher by adjusting the three levelling legs individually. 3 When level the dishwasher, please pay attention not to let the dishwasher tip over. Figure 8 Illustration of feet adjustment Chec k level Front to Back NOTE: The maximum adjustment height of the feet is 50 mm.
PAGE 21
The appliance mus t be connected to the water mains using n ew hose-sets. The old hose-sets sho uld not be reused. Wate r pressure must b e between 0,04 MPa and 1 MPa. If the pressu re is below the minimum consult our Service Department for advice. 1 2 3 Pull The safety supply hoses completely out from storage compartment located at rear of dishwasher. Tighter the screws of the safety supply hose to the faucet with thread 3/4inch. Turn water fully on before starting the dishwasher.
PAGE 22
The following things should be checked before starting the dishwasher. 1 The dishwasher is level and fixed properly 2 The inlet valve is open 3 There is a leakage at the connections of the conducts 4 The wires are tightly connected 5 The power is switched on 6 The inlet and drain hoses are knotted 7 All packing materials and printings should be taken out from the dishwasher After installation, please make sure to keep this manual. The content of this manual is very helpful to the users.
PAGE 23
Fuse blown, or the home Replace fuse or reset circuit breaker. Remove any other circuit breaker has been appliances sharing the same circuit with the dishwasher triggered. Make sure the dishwasher is turned on and the door is Power supply is not closed securely. turned on Make sure the power cord is properly plugged into the wall socket. Error code:E1; Water pressure is low Check that the water supply is connected properly and the water is turned on. Door of dishwasher not properly closed.
PAGE 24
The dishes were not loaded correctly. See notes in " Loading the Dishwasher Baskets ". The programme was not powerful enough. Select a more intensive programme. See" Wash Cycle Table ". Not enough detergent was dispensed. Use more detergent, or change your detergent. Items are blocking the path of spray arms. Rearrange the items so that the spray can rotate freely. The filter combination in the base of wash cabinet is not clean or is not correctly fitted.
PAGE 25
If overflow occurs, turn off the main water supply before calling a service. If there is water in the base pan because of an overfill or small leak, the water should be removed before restarting the dishwasher. Height : Width : Depth : Water pressure: Power supply: Capacity: 815mm 598 mm 550mm ( with the door closed ) 0.04-1.
PAGE 26