Product Manual

11
ANTI-TILT BRACKET
Important!
To restrain the appliance and prevent
it tipping accidentally, t a bracket to
its rear to x it securely to the wall.
Make sure you also t the supplied
lock pin to the anti-tilt bracket.
To t the anti-tilt bracket:
1. After you have located where the
cooker is to be positioned, mark on
the wall the place where the two
screws of the anti-tilt bracket have to be tted.
Please follow the indications given in g. 6a.
2. Drill two 8 mm diameter holes in the wall and
insert the plastic plugs supplied.
 Important!
 Before drilling the holes, check that you will
not damage any pipes or electrical wires.
3. Loosely attach the anti-tilt bracket with the two
screws supplied.
4. Move the cooker to the wall and adjust the height
of the anti-tilt bracket so that it can engage in the
slot on the cooker’s back, as shown in g. 6a.
5. Tighten the screws attaching the anti-tilt bracket.
6. Push the cooker against the wall so that the
antitilt bracket is fully inserted in the slot on the cooker’s back.
7. Access the bracket and t the lock pin:
■ Remove the drawer (g. 6b).
■ Fit the lock pin through the bracket, as shown (g. 6c).
■ Ret the drawer.
=
=
min 215 mm - max 265 mm
(depending on feet
height adjustment)
0
+50
Dotted line showing the position of
the cooker when installed
1
2
Fitting the lock pin through
the bracket
Lock pin
correctly
fitted
Lock pin
Slot on the
cooker’s back
Cooker’s
back
Anti-tilt bracket
attached on the
rear wall
Figure 6a
Figure 6b
Figure 6c