Installation and Operation Guide

36
REFIT THE DOOR
1. Hold the door rmly (g. 34).
2. Insert the hinge tongues into the slots, making sure that the groove drops into place
as shown in the gure 35.
3. Open the door to its full extent.
4. Fully close the levers “A” on the left and right hinges, as shown in the gure 36.
 IMPORTANT NOTE: For the hinge tted with the damper pin, push the hinge lever
towards the damper pin and keep depressed. The damper pin will move into the oven
chassis slowly, allowing the hinge lever to fully rotate.
5. Close the door and check that it is properly in place.
Figure 34
Figure 35 Figure 36
A