Operating instructions

9 Electrical installation
Before effecting any intervention on the electrical parts of the appliance, the con-
nection to the network must be interrupted.
IMPORTANT: The cooker must be installed in accordance with the manufacturer’s
instructions.
Incorrect installation, for which the manufacturer accepts no responsibility, may
cause injury to persons or animals etc.
This appliance must be installed by a qualified technician according with the current local
regulations and in compliance with the manufacturer instructions.
– Connection to the mains must be carried out by qualified personnel in accordance with
current regulations.
– The appliance must be connected to the mains checking that the voltage corresponds to
the value given in the rating plate and that the electrical cable sections can withstand the
load specified on the plate.
– The appliance can be connected directly to the mains placing an omnipolar switch with
minimum opening between the contacts of 3 mm between the appliance and the mains.
– The power supply cable must not touch the hot parts and must be positioned so that it
does not exceed 75°C at any point.
– Once the appliance has been installed, the switch or socket must always be accessible.
N.B. For connection to the mains, do not use adapters, reducers or branching
devices as they can cause overheating and burning.
If the installation requires alterations to the domestic electrical system or if the socket and
appliance plug are incompatible, call an expert.
He should also check that the socket cable section is suitable for the power absorbed by
the appliance.
IMPORTANT: this cooker must be connected to a suitable double pole control
unit adjacent to the cooker.
NO DIVERSITY CAN BE APPLIED TO THIS CONTROL UNIT.
IMPORTANT:
This appliance must be earthed.
34