Operation Manual

9
No milk froth is formed when
making cappuccino
• Milk not cold enough.
• Cappuccino maker dirty.
• Always use semi-skimmed milk at
refrigerator temperature.
• Thoroughly clean the holes in the
cappuccino maker in particular those
indicated in figure 19.
PROBLEM
POSSIBLE CAUSES SOLUTION
No espresso coffee is
delivered
• No water in the tank
• The holes in the filter holder spouts
are blocked.
• The espresso boiler outlet is blocked.
• The filter is blocked
• The tank is incorrectly inserted and
the valve on the bottom is not open.
The espresso coffee drips
from the edges of the filter
holder rather than the holes
- The filter holder is inserted incorrectly.
- The espresso boiler gasket has lost
elasticity.
- The holes in the filter holder spouts
are blocked.
• Attach the filter holder correctly and
rotate firmly as far as it will go.
• Have the espresso boiler gasket
replaced at a service centre.
• Clean the spout holes
The espresso coffee is cold
• The espresso OK indicator light was
not on when the coffee switch was
pressed.
• No preheating performed
• The cups were not preheated
• Wait until the espresso OK indicator
light comes on.
• Preheat as described in the
paragraph "Preheating the espresso
coffee unit".
• Preheat the cups.
The pump is excessively noisy
• The water tank is empty.
• The tank is incorrectly inserted and
the valve on the bottom is not open.
•
Refill the tank.
•
Press the tank down lightly to open
the valve on the bottom.
• Fill the tank with water.
• Clean the spout holes
• Clean as described in the chapter
"Cleaning the boiler outlet".
• Clean as described in the section
"Cleaning the filter".
• Press the tank down lightly to open
the valve on the bottom.
The coffee froth is too
light (delivered from the
spout too fast)
• The ground coffee is not pressed
down firmly enough.
• There is not enough ground coffee.
• The ground coffee is too coarse
• Incorrect type of ground coffee.
• Press the ground coffee down more
firmly (fig.5).
• Increase the quantity of ground
coffee.
• Use ground coffee for espresso
coffee machines only.
• Change the type of ground coffee.
The coffee froth is too dark
(delivered from the spout too
slowly)
•
The ground coffee is pressed down
too firmly.
•
There is too much ground coffee.
•
The espresso boiler outlet is blocked.
•
The filter is blocked
•
The ground coffee is too fine.
•
The coffee is damp or ground too
fine.
•
Incorrect type of ground coffee.
•
Press the coffee down less firmly (fig.
6).
•
Reduce the quantity of ground coffee.
•
Clean as described in the chapter
"Cleaning the espresso boiler outlet".
•
Clean as described in the section
"Cleaning the filter".
•
Use ground coffee for espresso coffee
machines only.
•
Use only ground coffee for espresso
coffee machines. Make sure it is not
damp.
•
Change the type of ground coffee.