Instruction Manual

9
Setting water hardness
The light (V2) indicating that the appliance needs descaling
comes on after a period of operation established according to
water hardness.
The appliance can also be programmed according to the hard-
ness of the mains water in the various regions so that descaling
needs to be performed more or less frequently.
Proceed as follows:
1. Access the settings menu;
2. Press the
button to enter the water hardness selec-
tion mode. The lights corresponding to the current selec-
tion come on:
soft
medium
hard
3. The lights start ashing in sequence;
4. Press the button corresponding to the water hardness in
your area:
soft
water
medium
water
hard
water
<10°dH 10°dH - 20°dH >20°dH
<18°fH 18°fH - 36°fH >36°fH
<180mg/l CaCo
3
180-300mg/l CaCo
3
360mg/l CaCo
3
- The button ashes to indicate that the selection has
been saved.
The appliance exits the menu and is ready for use.
Adjusting auto-o (stand-by)
To save energy, an auto-o function turns the appliance o
when not used for a long period.
To turn it back on again, press any button on the control panel.
1. Access the settings menu;
2. Press the
button to enter the auto-o time selection
mode. The lights corresponding to the current selection
come on:
9 min
30 min
3 hours
3. The lights start ashing in sequence;
4. Press the button corresponding to the required time:
9 min 30 min 3 hours
5. The
button ashes to indicate that the selection has
been saved.
The appliance exits the menu and is ready for use.
Default values (reset)
This resets all menu settings and programmed quantities back
to the default values.
To reset the default values, proceed as follows:
1. Access the settings menu;
2. Turn the steam dial to the
position;
3. Press the
button. The three lights ash simulta-
neously to conrm that the original settings have been
restored.
4. The
and lights ash to indicate that the
steam dial must be closed again (○symbol).
When the steam dial has been closed, the appliance is ready for
use.
HOW TO MAKE ESPRESSO COFFEE
Tips for a hotter coee
For hotter espresso coee, you should:
• Attach the lter holder to the appliance with the lter in
place but without adding coee.
Using the same cup as will later be used to make the coee,
press the 1 cup button and deliver hot water into the cup to
heat it.
• Raise the coee temperature in the settings menu.
• Rest the cups you will be using on the cup warmer (D)
which becomes hot during operation.
How to make espresso coee using pre-ground
coee
1. Place the ground coee lter (P or Q) in the lter holder
(g. 6). To make one coee, use the lter with the
symbol on the bottom, to make two coees, use the lter
with the
symbol on the bottom.
2. To make just one coee, place one level measure of pre-
ground coee (about 7 g) in the lter (g. 7).
To make two coees, place two loosely lled measures
(about 7+7 g) of pre-ground coee in the lter. Fill the
lter a little at a time to prevent the pre-ground coee
from overowing.
Important: