COFFEE MAKER
49
名称和产品中有害物质的含量 Name and content of hazardous substances in products 组件 名称 有害物质 铅 汞 镉 六价铬 多溴联苯 多溴Ҽ苯䟊 Lead Mercury Cadmium He[aYalent Polybrominated Polybrominated (Pb) (HJ) (Cd) Chromium biphenyls diphenyl ethers ○ ○ ○ (Cr (9,)) P%% P%'( X ○ X Components Name Hazardous substances 塑料外壳 和底盘 ○ （ ） ○ （ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ X ○ X ○ ○ ○ ○ ） Plastic enclosure and chassis 印刷电路板 组㻵 Printed Circuit %oard Assembly 电机、阀门 Motors YalYes 电㔶和电㓯 Cable an
1. FUNDAMENTAL SAFETY WARNINGS • The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. • Children should be supervised to ensure that they do not play with the appliance.
• • • The appliance can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they are supervised or have been given instruction concerning use of the appliance in a safe way and if they understand the hazards involved. Children shall not play with the appliance. Always unplug the appliance when left unattended and before assembly, taking apart or cleaning.
• • 3.3 4. REGULATORY REFERENCES The appliance could be damaged if the water it contains freezes. Do not install the appliance in a room where the temperature could drop below freezing point. Arrange the power cord in such a way that it cannot be damaged by sharp edges or contact with hot surfaces (e.g. electric hot plates). This product complies with European regulation no. 1935/2004 on materials and articles intended to come into contact with food. 5.
B6. Hot water button B7. button: to customise beverage quantity B8. Mode selector dial: • Espresso • Americano • Coffee • Descaling B9. Descale light B10. Steam ready light B11. Overtemperature light B12. Energy saving light B13. General alarm light B14. Beans container empty/No beans container light B15. No water light B16. Pressing light B17. Pressure gauge 1.3 2.
The first time you use the appliance, we recommend using the factory setting (medium grinding) (fig. 14), then if you are not satisfied with the result, adjust the level according to your personal taste and the type of coffee by setting a finer or coarser grinding level, referring to the tips in section "4.5 Adjusting the quantity of ground coffee in the filter". Important: • Always adjust the coffee mill while in operation.
C2 4. Using the dial (B8), select the desired beverage. 5. Press the button. The appliance makes the coffee then stops automatically. Please note: While the machine is making coffee, delivery can be interrupted at any moment by pressing the button. To remove the filter holder, turn the handle from right to left. Coffee ✗ • Pressure gauge • 1 cup 35 ml ✓ 2 cups 70 ml C3 C2 ✗ RECOMMENDED: 1 cup 240 ml C3 ✓ C3of coffee in the filter Always check that there is the right amount (see section "4.
Recommended position 6. Press the button to save the new setting. The appliance is ready for use again and the button remains on. If you do not want to save the new setting, press any other button. Programming Americano coffee: follow the procedure described above for the quantities of both coffee and hot water. Please note: • • • 6.
12.2 Water hardness 6. Replace the connection nozzle, move the ring downwards and put the cappuccino maker back on the nozzle, turning it and pushing it upwards until it is attached. For more thorough cleaning, use De’Longhi detergent. The descale light (B9) comes on after a period of time established according to water hardness. The machine can also be programmed according to the actual hardness of the water supply in the various regions, in which case descaling may be required less frequently.
Button 4. Press the button (B1) to exit the menu. (If the appliance is left idle for about 1 minute, it exits automatically from the settings menu and is ready for use again); 5. Turn the ground coffee quantity dial (B2) to the "min” position, then proceed to adjust as if it were the first time ("4.5 Adjusting the quantity of ground coffee in the filter"). Time 9 minutes 1.5 hours 3 hours 4. Press the button (B1) to exit the menu.
flow the edge and damage the appliance, the surface it rests on or the surrounding area. If still dirty, and in any case always at least once a month, clean the coffee filters thoroughly: 1. Extract the perforated filter by pulling the tab (fig. 38). 1. Remove the drip tray (fig. 33). 2. Remove the cup grille (A11), drip tray grille (A12) and level indicator (A14), empty the water and clean all the components with a cloth, then reassemble the drip tray. 3. Put the drip tray back in place. 13.
13.7 Cleaning the beans container Without extracting it, clean the beans container regularly with a cloth. For more thorough cleaning, proceed as follows: 1. Make sure the beans container (A2) is empty. If necessary, operate the coffee mill without beans to empty it: 2. Release the beans container by turning it anticlockwise and extract from the appliance. 3. Wash the container and lid (A1) with warm water.
13.9 Replacing the burrs 13.11 Other cleaning operations When the quantity of coffee becomes even less, contact a customer services centre to have the burrs replaced, then adjust the mill again as follows: 1. Press and hold the (B3) and (B7) buttons for at least 3 seconds to access the menu. The (B15) and (B16) lights alternate; 2. Turn the mode selection dial (B8) to the position. The light (B14) remains on steadily; 3. Select the original grinding range by pressing the button; 4.
15. TECHNICAL DATA Mains voltage: Absorbed power: Size LxDxH: MAX. pressure: Water tank capacity: Power cable length: Weight: 220-240V˜50-60Hz 1450W 375x368x445 mm 19 bars 2L 1200 mm 12 kg 16.
17. EXPLANATION OF LIGHTS LIGHTS EXPLANATION OF LIGHTS OPERATION All the lights flash briefly Turning the machine on Self-diagnosis Insufficient water in tank or water tank Fill the tank or extract the tank and put it not inserted correctly back correctly on Energy saving is enabled See section "12.5 Energy saving" if you want to disable the function The appliance is on and ready for use The appliance is at the right temperature to deliver steam.
LIGHTS ALARM SOLUTION Descaling must be performed Descale the appliance as described in section "14. Descaling" flashing quickly The dial (B8) is in the descaling position Turn the dial to one of the beverage positions + The filter holder has been detached be- Repeat grinding fore grinding has ended or pressing has been performed too quickly on + flashing flashing The coffee mill coffee guide is clogged Clean as described in section "13.
LIGHTS ALARM + flashing SOLUTION If the water softener filter (C6) is present, Press the button (B6) corresponding to an air bubble may have been released in- the light (fig. 9). Delivery begins side the circuit, obstructing delivery and stops automatically. The grinding is too fine and the coffee is Extract the filter holder and repeat the delivered too slowly or not at all operations to make the coffee, bearing in mind the indications in section "4.
PROBLEM CAUSE SOLUTION The espresso coffee drips from the The filter holder is inserted incorrectly edges of the filter holder rather than the holes The espresso boiler gasket has lost elasticity or is dirty Attach the filter holder correctly and rotate firmly as far as it will go Have the espresso boiler gasket replaced by Customer Services The filter is clogged, or the perforated Clean as described in section "13.
PROBLEM CAUSE SOLUTION If you want to change the type of coffee You must remove all the beans present • in the machine • • • After grinding, the coffee filter is empty The coffee mill coffee guide is clogged After grinding, there is too much coffee in the filter Empty the beans container (if necessary, operate the coffee mill without beans or use a vacuum cleaner to remove any remaining beans).
5713245211_00_0719 De’Longhi Appliances via Seitz, 47 31100 Treviso Italia www.delonghi.
