EC933X COFFEE MAKER Instructions for use
B1 B16 B17 B15 B14 B12 B13 B11 B10 B9 B2 B3 B4 B5 B6 C4 C1 B7 B8 C5 C6* C2 C9 C3 C7 2 C8
A1 A2 A3 A23 A4 A5 A6 A22 A9 A7 A21 A8 A10 A13 A12 A15 A16 A11 A17 A18 A19 A20 A14 3
MAX 1 2 3 4 5 6 7 8 9 10 11 12 15 16 0,5 L 14 13 4
✓ 17 18 19 20 21 22 23 24 26 27 28 30 31 32 25 MAX 29 ✗ ✗ 5
Before using the appliance, always read the safety warnings. This appliance shall not be used by children. Keep the appliance and its cord out of reach of children. B12. Energy saving light B13. General alarm light B14. Beans container empty/no beans container light B15. No water light B16. Pressing light B17. Pressure gauge 1. DESCRIPTION 1.3 1.1 Description of the appliance (page 3 - A ) A1. Beans container lid A2. Beans container A3. Cup tray A4. Steam dial A5. Hot water spout A6. Steam spout A7.
with "INSERT" (fig. 10), then turn the handle to the right until it is aligned in the "CLOSE" position; 6. Place a recipient under the filter holder and cappuccino maker (A8) (fig. 11); 7. Press the button (B4) corresponding to the light (fig. 12). Delivery begins; 8. When delivery is complete, turn the steam dial (A4) (fig. 13) and deliver steam for 10 seconds to rinse the steam circuit; 9. Repeat points 7 and 8 until you have delivered at least 1 litre of water (about half the tank); 10.
5.3 Auto-off 6. MAKING COFFEE Auto-off can be set so that the appliance goes off after 15 minutes, one and a half hours, or three hours. Proceed as follows: 1. Press and hold the (B3) and (B7) buttons together (B15) for at least 3 seconds to access the menu. The (B16) lights alternate; and COFFEE posi2. Turn the mode selection dial (B8) to the tion. The (B13) remains on steadily; 3. Press the button corresponding to the desired selection as shown in the following table: Button 4. 5.4 6.
Always check that the coffee quantity in the filter is correct (see paragraph "6.8 Adjusting the quantity of ground coffee in the filter"). the result may not be satisfactory. The next times you use the coffee mill, you can adjust the grinding level using the dial (B2) (see section "6.8 Adjusting the quantity of ground coffee in the filter"). • 6.6 LONG BLACK This long coffee is a favourite in Australia and New Zealand. Hot water is delivered first, followed by the espresso directly into the cup.
6.9 Delivering the coffee Cappuccino, Espresso Macchiato, Hot Milk (frothed) 1. Attach the filter holder (C1) to the appliance. To attach correctly, align the filter holder handle with "INSERT" (fig. 10) then turn the handle to the right until it is aligned in the "CLOSE" position; 2. Place the cup or cups under the filter holder spouts; 3. If you are using small cups, lower the cup grille (A10) to bring the filter holder spouts nearer the cup. This makes a better froth (fig. 25); 4.
3. To stop delivery, press again the button. You should not deliver hot water for more than 60 seconds. 11. CLEANING 11.
11.5 Cleaning the boiler outlet 1. Remove the drip tray (fig. 35). 2. Remove the cup grille (A7), the drip tray grille (A12) and the drip tray water level indicator (A14), empty the water and clean the tray with a cloth, then reassemble the drip tray. 3. Put the drip tray back in place. After every 200 coffees, rinse the boiler outlet: Press the rinsing button (B4) until around 500 ml of water is delivered. 11.3 Cleaning the small cup grille 1.
• verify that the burr is well inserted by pulling it by the handle: the burr is correctly inserted if it does not move; 8. Use a brush to remove any coffee residues from the outlet of the coffee mill (A22). 4. Turn the fineness selector anticlockwise as far as it will go to the "REMOVE" position (fig. 41). 11.9 Extra grinding adjustment 41 5. Over time, the burrs will wear down and the quantity of ground coffee will diminish. When the grinding adjustment illustrated on the "6.
11.11 Other cleaning operations 11. When rinsing is complete, delivery stops. All the LEDs flash briefly and the appliance prepares to be used again. 12. Empty the recipient used to collect the rinse water. 13. Extract and empty the drip tray, then put back in the appliance. 14. Extract the tank, fill with fresh water, then put back in the appliance. 15. Turn the mode selector dial to one of the coffee positions. 1. Do not use solvents or abrasive detergents to clean the coffee maker.
14.
15. EXPLANATION OF LIGHTS LIGHTS EXPLANATION OF LIGHTS OPERATION All the lights flash briefly Turning the machine on Self-diagnosis on Insufficient water in tank or water tank Fill the tank or extract the tank and put it not inserted correctly back correctly Energy saving is enabled See section "5.5 Energy saving" to disable the function The appliance is on and ready for use The appliance is at the right temperature to deliver steam.
16. ALARMS LIGHTS + ALARM SOLUTION on General alarm Contact Customer Services on steadily The drip tray (A13) is missing or has not Extract the drip tray then put back corbeen inserted correctly rectly in the appliance on Descaling must be performed Proceed as described in section "12.
. TROUBLESHOOTING PROBLEM CAUSE SOLUTION Espresso coffee is not delivered any No water in the tank (A17) Fill the tank more Press the button corresponding to the light is on and the The light. light is flashing to indicate that the coffee or steam circuit is empty. The filter is blocked, or the perforated Clean as described in section "11.
PROBLEM CAUSE SOLUTION After grinding, the coffee filter is empty The coffee mill coffee guide is clogged After grinding, there is too much coffee in the filter If you want to change coffee quality Clean as described in section "11.10 Cleaning the "tamping station"". If the problem persists, access the guide by opening the hatch and free it using the brush(fig. 50). All the coffee beans in the machine • must be removed • • 19 Empty the bean container (if necessary, vacuum the remaining beans).
