User's Manual

9
5. CLEANING AND MAINTENANCE
5.1 Cleaning the machine
The following parts of the machine must be cleaned regularly:
- drip tray (A11) complete with cup grille (A9) and drip tray
grille (A10);
- espresso cup grille (A8);
- coee lters (C2) and (C3);
- the beans container (A1);
- the coee mill burrs;
- the coee mill outlet (A18) (smart tamping station);
- boiler outlet (A7);
- water tank (A15);
- steam wand (A5);
- Lattecrema system (D).
Important!
• Do not use solvents, abrasive detergents or alcohol to clean
the coee machine.
• Do not use metal objects to remove encrustations or coee
deposits as they could scratch metal or plastic surfaces.
• None of the components of the appliance can be washed in
a dishwasher with the exception of the drip tray (A11) and
cup grilles (A8) and (A9).
• If the appliance is not used for more than a week, before
using it again, we recommend you perform a rinse cycle.
Danger!
• While cleaning, never immerse the coee maker in water. It
is an electrical appliance.
• Before cleaning the outside of the appliance, turn it o,
unplug from the mains socket and allow to cool.
5.2 Cleaning the drip tray
The drip tray is tted with a level indicator (A12) (g. 7) showing
the amount of water it contains. Before the indicator protrudes from
the cup tray, the drip tray must be emptied and cleaned, otherwise
the water may overow the edge and damage the appliance, the
surface it rests on or the surrounding area.
7 8
1. Remove the drip tray (g. 8).
2. Remove the cup grille (A9), drip tray grille (A10) and level
indicator (A12), empty the water and clean all the compo-
nents with a cloth, then reassemble the drip tray.
3. Put the drip tray back in place.
5.3 Cleaning the espresso cup grille
1. Extract the grille (A8) by pulling it from the left, then re-
moving it from the support (g. 9).
2. Clean the support with a cloth and wash the grille (dish-
washer safe).
3. Put the grille back on the support from the right side, then
push until it is correctly attached (g. 10).
9 10
1
2
1
22
2
1
5.4 Coee lter cleaning and maintenance
The coee lters are designed to
obtain the best possible coee
extraction and crema. For best
results, the lters must always
be clean and free from all coee
residues.
After using the appliance, al-
ways rinse the lters under
abundant running water (g.
11) or by Active Rinse function
(B5).
5.5 Cleaning of the coee outlet
When the light comes on (orange) (B5), you have to pro-
ceed cleaning the coee circuit. To run the cleaning, you have to
purchase dedicated cleaning tabs for coee makers.
Proceed as follows:
1. Insert the 1-cup coee lter (C2) in the portalter (C1);
2. Put on the coee lter the special disk accessory (C10) (g.
12) and press it to the bottom;
3. Put on the accessory the cleaning tab (g. 13);
4. Attach the portalter to the coee outlet (A7);