Instruction Manual

21
INSERT TANK The tank (A10) is not correctly in place. Insert the tank correctly and press as far as it
will go.
GENERAL ALARM The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly,
as described in section “14. Cleaning”. If the
message is still displayed after cleaning, con-
tact a service centre.
REPLACE FILTER The water softener lter (C4) is exhausted. Replace the lter or remove it as described in
section “17. Water softener lter”.
SET DIAL TO CLEAN Milk has been delivered recently and the tubes
inside the milk container must be cleaned.
Turn the froth adjustment dial (D1) to the
CLEAN position.
INSERT WATER SPOUT The hot water spout is not inserted or is inser-
ted incorrectly.
Insert the water spout (C6) as far as it will go.
WATER CIRCUIT EMPTY FILL
WATER CIRCUIT
alternating with...
HOT WATER PRESS OK
The water circuit is empty. Press OK to deliver water from the hot water
spout (C6) until it ows out normally.
If the problem persists, make sure the water
tank (A10) is fully inserted.
INSERT MILK CONTAINER The milk container (D) is not inserted correctly. Insert the milk container (g. 13) as far as it
will go.
21. TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM POSSIBLE CAUSE SOLUTION
The coee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot
water (Please note: you can use the hot water
function).
The internal circuits have cooled down be-
cause 2/3 minutes have elapsed since the last
coee was made.
Before making coee, heat the internal circuits
by using the
rinse function (see section “9.
Rinsing”).
A low coee temperature is set. Set a high coee temperature in the menu.
The coee is weak or not cre-
amy enough.
The coee is ground too coarsely. Turn the grinding adjustment dial (A2) one
click anticlockwise towards “1” while the coee
mill is in operation (g. 8). Continue one click
at a time until coee delivery is satisfactory.
The eect is only visible after delivering 2
coees (see section “10.3 Adjusting the coee
mill”).
The coee is unsuitable. Use pre-ground coee for espresso machines.