Instruction Manual

16
• Empty the grounds container and clean thoroughly to re-
move all residues left on the bottom;
• Check the condensate tray (A15) (red) and empty if
necessary.
Important!
When removing the drip tray, the grounds container must be
emptied, even if it contains few grounds.
If this is not done, when you make the next coees, the grounds
container may ll up more than expected and clog the machine.
14.4 Cleaning the drip tray and condensate tray
Important!
If the drip tray (A18) is not emptied regularly, the water could
overow from the edge and seep inside or around the machine.
This could damage the machine, the surface it rests on or the
surrounding area.
The drip tray is tted with a level indicator (A17) (red) showing
the level of water it contains (g. 23). Before the indicator pro-
trudes from the cup tray (A16), the drip tray must be emptied
and cleaned.
To remove the drip tray:
1. Remove the drip tray and the grounds container (A14) (g.
22);
2. Empty the drip tray and grounds container and wash them;
3. Check the condensate tray (A15) (red) and empty if
necessary;
4. Replace the drip tray and grounds container.
14.5 Cleaning the inside of the coee machine
Danger!
Before cleaning internal parts, the machine must be turned o
(see section “7. Turning the appliance o”) and unplugged from
the mains power supply. Never immerse the coee machine in
water.
1. Check regularly (about once a month) that the inside of the
appliance (accessible after removing the drip tray - A18)
is not dirty. If necessary, remove coee deposits with the
brush (C5) or a sponge;
2. Remove all the residues with a vacuum cleaner (g. 24).
14.6 Cleaning the water tank
1. Clean the water tank (A10) regularly (about once a month)
and whenever you replace the water softener lter (C4, if
provided) with a damp cloth and a little mild washing up
liquid;
2. Remove the lter (if present) and rinse with running water;
3. Replace the lter (if provided), ll the tank with fresh
water and replace the tank;
4. (Models with water softener lter only) Deliver about
100ml of hot water to reactivate the lter.
14.7 Cleaning the coee spouts
1. Clean the coee spouts (A13) with a sponge or cloth (g.
25A);
2. Check that the holes in the coee spouts are not blocked.
If necessary, remove coee deposits with a toothpick (g.
25B).
14.8 Cleaning the pre-ground coee funnel
Check regularly (about once a month) that the pre-ground cof-
fee funnel (A6) is not blocked.
If necessary, remove coee deposits with the brush (C5).
14.9 Cleaning the infuser
The infuser (A12) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned o (see section
“7. Turning the appliance o”);
2. Remove the water tank (A10);
3. Open the infuser door (A11) (g. 26) on the right side of
the appliance;
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (g. 27);
Important!
RINSE WITH WATER ONLY NO WASHING UP LIQUID  NO
DISH WASHER
Clean the infuser without using washing up liquid as it
could be damaged.
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
6. Use the brush (C5) to remove any coee residues left in the
infuser housing, visible through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the
internal support (g. 28), then push the PUSH symbol fully
in until it clicks into place;
Please note :
If the infuser is dicult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in g. 29.
8 Once inserted, make sure the two coloured buttons have
snapped out (g. 30);
9. Close the infuser door;
10. Put the water tank back.