Instruction Manual

20
20. DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION
FILL TANK Insucient water in the tank (B10). Fill the tank with water and/or insert it cor-
rectly, pushing it as far as it will go until it clicks
into place (g. 4).
EMPTY GROUNDS CONTAINER The grounds container (A14) is full. Empty the grounds container and drip tray
(A18), clean and replace (g. 23).
Important: when removing the drip tray, the
grounds container (A14) must be emptied,
even if it contains few grounds. If this is not
done, when you make the next coees, the
grounds container may ll up more than ex-
pected and clog the machine.
GROUND TOO FINE ADJUST
MILL
The grinding is too ne and the coee is deli-
vered too slowly or not at all.
Repeat coee delivery and turn the grin-
ding adjustment dial (A2) (g. 8) one click
clockwise towards “7” while the coee mill is
in operation. If after making at least 2 coees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click until delivery is correct (see
section: “10.3 Adjusting the coee mill”). If the
problem persists, turn the steam dial to the I
position and deliver a little water from the hot
water spout (C6).
If the water softener lter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
Insert the hot water spout (C6) in the appliance
and deliver a little water until the ow beco-
mes regular.
INSERT GROUNDS CONTAINER After cleaning, the grounds container (A14)
has not been replaced.
Remove the drip tray (A18) and insert the
grounds container.
ADD PREGROUND COFFEE The “pre-ground coee” function has been se-
lected without placing any pre-ground coee
in the funnel (A6).
Place pre-ground coee in the funnel or dese-
lect the “pre-ground” function.
DESCALE The machine must be descaled. The descaling procedure described in section
“15. Descaling” needs to be performed as soon
as possible.
REDUCE COFFEE AMOUNT Too much coee has been used. Select a milder taste or reduce the quantity of
pre-ground coee.
FILL BEANS CONTAINER The coee beans have run out. Fill the beans container (A7).
The pre-ground coee funnel (A6) is clogged. Empty the funnel with the help of a brush (C5)
as described in section “14.8 Cleaning the pre-
ground coee funnel”.
INSERT INFUSER ASSEMBLY The infuser (A12) has not been replaced after
cleaning.
Insert the infuser as described in section “14.9
Cleaning the infuser”.