Instruction Manual

9
Connecttheappliancetoanecientlyearthedandcorrectly
installed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualied
professional.
Setting up the appliance
Please note :
• Coeehasbeenusedtofactorytesttheapplianceanditis
therefore completely normal for there to be traces of cof-
fee in the mill. The machine is, however, guaranteed to be
new.
• Youshouldcustomisewaterhardnessassoonaspossible
following the instructions in the section “Setting water
hardness” on page 16.
1. Insert the power cable connector into the socket at the
back of the appliance and connect the appliance to the
mains electricity supply (g. 1). Make sure the main switch
at the back of the appliance is pressed (g. 2).
You must rst choose the language (the languages scroll
through at intervals of about 3 seconds):
2. When English appears, press the button (g. 3)
for a few seconds until “ENGLISH set” is displayed.
Follow the instructions indicated on the appliance display:
3. “FILLTANK”:removethewatertank,lltotheMAXline
with fresh water (g. 4A), then replace in the appliance
(g. 4B).
4. “INSERT WATER SPOUT”: Check that the hot water spout is
inserted on the nozzle and place a container holding a mini-
mum of 100 ml underneath (g. 5).
5. “HOT WATER Conrm?” appears on the display.
6. Press the button to conrm. The appliance deliv-
ers water from the spout then goes o automatically.
The coee machine is now ready for normal use.
Please note :
• When setting up the appliance,you need to make 4/5
cups of coee or 4/5 cappuccinos before the appliance
starts to give satisfactory results.
TURNING THE APPLIANCE ON
Please note :
Before turning the appliance on, make sure the main switch on
the back of the appliance is pressed (g. 2).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted. The appli-
ance is ready for use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coee spouts
and is collected in the drip tray underneath. Avoid contact with
splashes of water.
• Toturntheapplianceon,pressthe button (g. 6).
The message “Heating up Please wait” is displayed.
After heating, the message “Rinsing” is displayed. As well as
heating the boiler, the appliance also heats the internal circuits
by circulating hot water.
The appliance is at temperature when the message “READY” is
displayed and the taste has been selected.
TURNING THE APPLIANCE OFF
Each time the appliance is turned o, it performs an automatic
rinse cycle which cannot be interrupted.
Danger of burns!
During rinsing, a little hot water ows from the coee spouts.
Avoid contact with splashes of water.
To turn the appliance o, press the button (g. 6). The
appliance performs a rinse cycle then goes o (stand-by).
Please note:
If you will not be using the appliance for some time, unplug
from the mains socket:
• rstturntheapplianceobypressingthe button
(g. 6);
• pressthemainswitch(g.2).
Important!
Never press the main switch while the appliance is on.
MENU SETTINGS
Press the MENU button to enter the settings menu.
Descaling
For instructions on descaling, see page 15.
Adjust time
To adjust the time on the display, proceed as follows:
1. Press the MENU button to enter the menu;
2. Press the or button until “Adjust time” is dis-
played;
3. Press the button;
4. Press the or button to change the hour;
5. Press the button to conrm;
6. Press the or button to change the minutes;
7. Press the button to conrm.
The time is set: press MENU to exit menu.