Instruction Manual

10
Auto-o
Auto-o can be set so that the appliance goes o after 15 or 30
minutes, or after 1, 2 or 3 hours.
1. Press the MENU button to enter the menu;
2. Press the or button until “Auto-o” is displayed;
3. Press the button;
4. Press the or until the number of hours of opera-
tion is displayed (15 or 30 minutes, or 1, 2 or 3 hours);
5. Press the button to conrm.
The auto-o is set. Press MENU to exit menu.
Auto-start
You can set the auto-start time in order to have the appliance
ready at a certain time (for example in the morning) so you can
make coee immediately.
Please note :
To enable this function, the time must already be set correctly.
1. Press the MENU button to enter the menu;
2. Press the or button until “Auto-start” is dis-
played;
3. Press the button. “Enable?” is displayed;
4. Press the button to conrm;
5. Press the or button to choose the hour;
6. Press the button to conrm;
7. Press the or button to change the minutes;
8. Press the button to conrm;
9. Then press MENU to exit menu.
Once the time has been conrmed, activation of auto-start is
indicated by the symbol displayed alongside the time and
under “Auto-start” in the menu.
To disable the function:
1. Select auto-start from the menu;
2. Press the button. “Disable?” is displayed;
3. Press the button to conrm.
The symbol is no longer displayed.
Setting the temperature
If you want to modify the temperature of the water used to
make the coee (low, medium, high, maximum), proceed as
follows:
1. Press the MENU button to enter the menu;
2. Press the or button until “Set temperature” is
displayed;
3. Press the button;
4. Press the or button until the required tempera-
ture is displayed (low, medium, high, maximum);
5. Press the button to conrm.
The temperature is set. Press MENU to exit menu.
Energy saving
Use this function to enable or disable energy saving.
When enabled, the function reduces energy consumption in
compliance with European regulations.
When energy saving mode is active, an asterisk appears below
“Energy saving” in the menu.
1. Press the MENU button to enter the menu;
2. Press the or button until “Energy saving” is dis-
played;
3. Press the button. “Enable?” or “Disable?” is dis-
played;
4. Press the button to enable or disable energy saving
mode;
Then press MENU to exit menu.
When the function is active, if the machine is not used for
about 1 minute, “Energy saving” is displayed.
Please note :
When in energy saving mode, a few seconds may elapse be-
fore the rst coee is delivered as the appliance must heat up
again.
Setting water hardness
For instructions on setting water hardness, see page 16.
Setting the language
To modify the language on the display, proceed as follows:
1. Press the MENU button to enter the menu;
2. Press the or utton until “Set language” is dis-
played;
3. Press the button;
4. Press the or button until the required language
is displayed ;
5. Press the button to conrm;
The language is set. Press MENU to exit menu.
Install lter
For instructions on how to install the lter, see the section “In-
stalling the lter” (page 16).
Remove lter
For instructions on how to remove the lter, see the section
“Installing the lter” (page 16).
Replace the lter
For instructions on how to replace the lter, see the section
“Replacing the lter” (page 17).
Default values (reset)
This resets all menu settings and programmed quantities back
to the default values (with the exception of the language