User Manual

15
14.5 Cleaning the inside of the coee machine
Danger of electric shock!
Before cleaning internal parts, the machine must be turned o
(see “7. Turning o”) and unplugged from the mains power sup-
ply. Never immerse the coee machine in water.
1. Check regularly (about once a week) that the inside of the
appliance (accessible after removing the drip tray) is not
dirty. If necessary, remove coee deposits with a sponge.
2. Remove the residues with a vacuum cleaner (g. 26).
14.6 Cleaning the water tank
1. Clean the water tank (A9) regularly (about once a month) and
whenever you replace the water softener lter (C4, if provid-
ed) with a damp cloth and a little mild washing up liquid.
2. Remove the lter (if present) and rinse with running water.
3. Replace the lter (if provided), ll the tank with fresh
water and replace the tank.
4. (Models with water softener lter only) Deliver about 100
ml of water.
14.7 Cleaning the coee spouts
1. Clean the coee spouts (A12) with a sponge or cloth (g.
27).
2. Check the holes in the coee spouts are not blocked. If nec-
essary, remove coee deposits with a toothpick (g. 28).
14.8 Cleaning the pre-ground coee funnel
Check regularly (about once a month ) that the pre-ground
coee funnel (A6) is not blocked. If necessary, remove coee
deposits.
14.9 Cleaning the infuser
The infuser (A11) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned o (see “7. Turn-
ing o”).
2. Remove the water tank (A9).
3. Open the infuser door (A10) (g. 29) on the right side of
the appliance.
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (g. 30);
Important!
Clean the infuser without using washing up liquid as it could
be damaged.
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap.
6. Clean coee residues from the support where the infuser
rests.
33
7. After cleaning, replace the infuser by sliding it onto the
internal support (g. 33), then push the PUSH symbol
until it clicks into place.
Please note:
If the infuser is dicult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in g. 34.
34
8. Once inserted, make sure the two coloured buttons have
snapped out (g. 35).
35
PUSH
9. Close the infuser door.
10. Put the water tank back.
15. DESCALING
Descale the appliance when the light (B5) (g. 31) on the
control panel ashes.
Important!
• Before use, read the instructions and the labelling on the
descaler pack.
Small lever
Large lever
Infuser