User Manual

18
FLASHING
The grounds container (A13) is full. Empty the grounds container and drip tray,
clean and replace. Important: when removing
the drip tray, the grounds container MUST be
emptied, even if it contains few grounds. If this
is not done, when you make the next coees,
the grounds container may ll up more than
expected and clog the machine.
After cleaning, the grounds con-
tainer has not been replaced
(A13).
Remove the drip tray and insert the grounds
container.
FLASHING
The grinding is too ne and the
coee is delivered too slowly or
not at all.
Repeat coee delivery and turn the grinding
adjustment dial (A2, g. 10) one click clock-
wise towards "7" while the coee mill is in
operation. If after making at least 2 coees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click until delivery is correct (see
"11.3. Adjusting the coee mill). If the prob-
lem persists, turn the steam dial (A19) to the
I position and deliver some water from the
cappuccino maker.
If the water softener lter (C4) is
present, an air bubble may have
been released inside the circuit,
obstructing delivery.
Deliver a little water from the cappuccino
maker by turning the steam dial (A19) to the I
position until the ow is regular (g. 5).
FLASHING
The "pre-ground coee" function
has been selected without placing
any pre-ground coee in the fun-
nel (A6).
Place pre-ground coee in the funnel or dese-
lect the “pre-ground” function.
FLASHING
The machine must be descaled. The descaling procedure described in the sec-
tion “15. Descaling" needs to be performed.
FLASHING
Too much coee has been used. Select a milder taste or reduce the quantity
of pre-ground coee, then make the coee
again.