User Manual

19
FLASHING
The coee beans have run out. Fill beans container.
The pre-ground coee funnel (A6)
is clogged.
Empty the funnel with the help of a brush as
described in the section "14.8. Cleaning the
pre-ground coee funnel".
FLASHING
The infuser has not been replaced
after cleaning (A11).
Insert the infuser as described in the section
“14.9. Cleaning the infuser".
The inside of the appliance is very
dirty.
Clean the inside of the appliance thoroughly,
as described in the section "14. Cleaning". If
the message is still displayed after cleaning,
contact a service centre.
20. TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM POSSIBLE CAUSE REMEDY
The coee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot water.
Please note: the hot water or rinse function can
be used.
The infuser has cooled down because 2/3
minutes have elapsed since the last coee was
made.
Before making coee, heat up the infuser by
pressing the rinse button.
The coee is weak or not
creamy enough.
The coee is ground too coarsely. Turn the grinding dial one click anticlockwise
while the grinder is in operation (g. 8). Con-
tinue one click at a time until coee delivery is
satisfactory. The eect is only visible after de-
livering 2 coees (see section "11.3Adjusting
the coee mill").
The coee is unsuitable. Use coee beans suitable for espresso
machines.
The coee is delivered too
slowly or a drop at a time.
The coee is ground too nely. Turn the grinding dial one click clockwise
while the grinder is in operation (g. 8). Con-
tinue one click at a time until coee delivery is
satisfactory. The eect is only visible after de-
livering 2 coees (see section "11.3. Adjusting
the coee mill").
Coee does not come out of
one or both of the spouts.
The spouts are blocked. Clean the spouts with a toothpick.