User Manual

10
• The appliance could be damaged if the water it contains
freezes.
Do not install the appliance in a room where the tempera-
ture could drop below freezing point.
• The appliance gives o heat. After positioning the appli-
ance on the worktop, leave a space of at least 3 cm be-
tween the surfaces of the appliance and the side and rear
walls and at least 15 cm above the coee machine.
• Water penetrating the coee machine could cause
damage.
Do not place the appliance near taps or sinks.
• Arrange the cord in such a way that it cannot be damaged
by sharp edges or contact with hot surfaces (e.g. electric
hot plates).
5.3 Connecting the appliance
Important!
Check that the mains power supply voltage corresponds to that
indicated on the rating plate on the bottom of the appliance.
Connect the appliance to an eciently earthed and correctly
installed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualied
professional.
5.4 Setting up the appliance
Please note:
• Coee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of cof-
fee in the mill. The machine is, however, guaranteed to be
new.
• You should customise water hardness as soon as possible
following the instructions in the section: “16. Setting water
hardness”.
Proceed as described:
1. Remove the water tank (A9), ll to the MAX line with fresh
water (g. 1A) then put back in the appliance (g. 1B).
2. Place a container with a minimum capacity of 100 ml
under the cappuccino maker (A18) (g. 2).
3. Plug the appliance into the mains socket and place the
main switch (A8) on the back of the appliance in the I posi-
tion (g. 3).
4. The light ashes on the control panel (B7, g. 4).
5. Turn the steam dial (A19) to the I position (g. 5). Water is
delivered from the cappuccino maker, then the appliance
goes o.
6. Turn the steam dial to the 0 position.
The coee machine is now ready for normal use.
Please note:
• The rst time you use the coee maker, you need to make
4/5 cups of coee or 4/5 cappuccinos before it starts to give
satisfactory results.
• To enjoy your coee even more and improve the perfor-
mance of your appliance, we recommend installing a water
softener lter (C4) as described in the section “10. WATER
SOFTENER FILTER”. If your model is not provided with a l-
ter, you can request one from De’Longhi Customer Services.
6. TURNING THE APPLIANCE ON
Please note:
• Before turning the appliance on, make sure the main
switch (A8) on the back of the appliance is in the I position
(g. 3).
• Each time the appliance is turned on, it performs an auto-
matic preheat and rinse cycle which cannot be interrupt-
ed. The appliance is ready for use only once this cycle is
complete.
Danger of burns!
During rinsing, a little hot water comes out of the coee spouts
(A12) and is collected in the drip tray underneath. Avoid contact
with splashes of water.
• To turn the appliance on, press the button (B2, g.
6). The light ashes while the appliance is heating up
and performing an automatic rinse cycle. By circulating hot
water, the appliance heats both the boiler and the internal
circuits.
The appliance is at temperature when the light goes o and
the coee lights come on.
7. TURNING THE APPLIANCE OFF
Whenever the coee machine is turned o after being used to
make coee, it performs an automatic rinse cycle.
Danger of burns!
During rinsing, a little hot water ows from the coee spouts
(A12).
Avoid contact with splashes of water.
To turn the appliance o, press the button (B2, g. 6). The
appliance performs a rinse cycle then goes o.
Please note:
If the appliance is not used for an extended period, place the
main switch (A8) in the 0 position (g. 3).
Important!
To avoid damaging the appliance, do not place the main switch
(g. 3) in the 0 position until you have turned the appliance o
with the button.