User Manual

11
8. AUTOOFF
The time can be changed so that the appliance switches o after
being idle for 15 or 30 minutes, or after 1, 2 or 3 hours.
To change the Auto-o setting, proceed as follows:
1. With the appliance o and the main switch (A8) in the I po-
sition (g. 3), press the button (B9) and hold it down
until the lights on the control panel come on.
2. Press the button (B3, on the left of the dial B6) until
the lights corresponding to the delay before the appliance
goes o automatically come on:
15 minutes ECO
30 minutes ECO
1 hour ECO
2 hours ECO
3 hours ECO
3. Press the button (B8, on the right of the dial) to
conrm the selection. The lights go o.
9. ENERGY SAVING
Use this function to enable or disable energy saving. When en-
abled, the function reduces energy consumption in compliance
with European regulations.
Energy saving mode is active when the green ECO light is on
(g. 7).
1. With the appliance o and the main switch (A8) in the I
position (g. 3), press the button (B7) and hold it
down until the ECO light (g. 7) come on.
2. To disable the mode, press the button (on the left of
the dial). The ECO light ashes.
3. To re-enable the mode, press the button (on the left of
the dial) again. The ECO light comes on steadily.
4. Press the button (on the right of the dial) to conrm
the selection. The ECO light goes o.
Please note:
When in energy saving mode, a few seconds may elapse before
the rst coee is delivered as the appliance must heat up again.
10. WATER SOFTENER FILTER CERTAIN MODELS ONLY
Certain models are tted with a water softener lter (C4). If this
is not the case with your model, you are recommended to pur-
chase one from De’Longhi Customer Services.
Important:
• Keep in a cool dry place out of direct sunlight.
• After opening the packaging, use the lter at once.
• Remove the lter before descaling the machine.
To use the lter correctly, follow the instructions below.
10.1 Installing the lter
1. Take the lter (C4) out of its packet and rinse under about
0.5 litre of running water (g. 8)
2. Turn the date indicator disk until the next two months of
use are displayed (g 9).
Please note:
The lter lasts about two months if the appliance is used nor-
mally. If the coee machine is left unused with the lter in-
stalled, it will last a maximum of three weeks.
3. Extract the tank (A9) from the appliance and ll with water
(g. 1A).
4. Insert the lter in the water tank and immerse it complete-
ly, sloping it to enable the air bubbles to escape (g. 10).
5. Insert the lter into the lter housing and press as far as it will
go (g.11).
6. Close the tank with the lid (g. 12), then replace the tank
in the machine.
7. Place a container with a minimum capacity of 500 ml
under the cappuccino maker (A18).
8. Turn the steam dial (A19) to the I position to deliver hot
water.
9. Deliver at least 500 ml of hot water, then turn the hot
water/steam dial back to the 0 position.
Please note:
Occasionally one delivery of hot water is not enough to install
the lter and the lights will come on
during installation.
If this happens repeat the installation procedure from point 8.
The lter is now active and you can use the coee machine.
10.2 Removal and replacement of the water
softener lter
After two months (see date indicator disk), or if the appliance
has not been used for 3 weeks, the lter (C4) must be removed
from the tank (A9) and replaced with a new one. Then the in-
stallation procedure above must be repeated.
11. MAKING COFFEE
11.1 Selecting the coee taste
Turn the coee taste selection dial (B9) to set the required taste.
Turning it clockwise increases the quantity of coee beans the
appliance will grind and therefore the strength of the coee
obtained.
Turn the dial to MIN for an extra mild coee and to MAX for an
extra strong coee.