User Manual

12
Please note:
• The rst time you use the appliance, you will need to make
a number of coees to identify the correct dial position
through trial and error.
• Do not turn the dial too far towards MAX, otherwise the
coee may be delivered too slowly (a drop at a time), par-
ticularly when making two cups of coee at the same time.
11.2 Selecting the quantity of coee in the cup
The appliance is set by default to automatically make the fol-
lowing quantities of coee:
- short coee when the button (B3) is pressed (≃40ml);
- long coee when the button (B8) is pressed
(≃120ml);
- two short coees when the button (B4) is pressed;
- two long coees when the button (B9) is pressed.
To change the quantity of coee the appliance delivers auto-
matically into the cup, proceed as described below:
- press the button corresponding to the quantity to be mod-
ied and hold it down until the light ashes and the appli-
ance starts delivering coee, then release;
- when the coee in the cup reaches the desired level, press
the same button again to memorise the new amount.
The machine is now reprogrammed with the new quantities.
11.3 Adjusting the coee mill
The coee mill is set by default to prepare coee correctly and
should not require regulating initially.
However, if after making the rst few coees you nd that the
coee is either too weak and not creamy enough or delivery is
too slow (a drop at a time), this can be corrected by adjusting
the grinding adjustment dial (A2) (g. 13).
Please note:
The grinding adjustment dial (A2) must only be turned when
the coee mill is in operation.
If the coee is delivered too slowly or
not at all, turn one click clockwise.
For fuller bodied creamier coee, turn
one click anticlockwise (do not turn
more than one click at a time other-
wise the coee could be delivered a
drop at a time).
These adjustments will only be evident after at least 2 cups of
coee have been delivered. If this adjustment does not obtain
the desired result, turn the dial another click.
11.4 Setting the temperature
To modify the temperature of the water used to make the coee,
proceed as follows:
1. With the appliance o and the main switch in the I position
(g. 3), press the button (B3) and hold it down until
the lights on the control panel come on;
2. Press the button to select the required temperature:
LOW HIGH
3. Press the button (B8) to conrm the selection. The
lights go o.
11.5 Tips for a hotter coee
For hotter coee, you should:
• before delivering the coee, perform a rinse cycle by press-
ing the button (B5). Hot water is delivered from
the spouts, heating the internal circuits of the appliance
and thus raising the coee temperature;
• warm the cups with hot water (using the hot water
function).
• set a hotter coee temperature (see the section “Setting
the temperature”).
11.6 Making coee using coee beans
Important!
Do not use caramelised or candied coee beans as they could
stick to the coee mill and damage it.
1. Fill the container (A7, g. 14) with coee beans.
2. Place under the coee spouts (A12):
- 1 cup, if you want to make 1 coee (g. 15);
- 2 cups, if you want 2 coees (g. 16).
3. Lower the spouts as near as possible to the cup. This makes
a creamier coee (g. 17).
4. Press the button corresponding to the required coee: