Owner's Manual

15
Important!
Descaler contains acids which may irritate the skin and eyes�
It is vital to respect the manufacturer’s safety warnings given on
the descaler pack and the warnings relating to the procedure to
follow in the event of contact with the skin and eyes�
Please note :
Use De’Longhi descaler only�
Under no circumstances should you use sulphamic or acetic
based descalers� Their use invalidates the guarantee�
Failure to descale the appliance as described also invalidates
the guarantee�
1� Turn the appliance on and wait until it is ready for use�
2� Empty the water tank (A9) and remove the softener lter,
if present�
3� Pour the descaler into the tank up to the level A
(corresponding to a 3�4oz/ 100ml pack) marked on the
back of the tank (g� 32A), then add water (1liter) up to
level B (g� 32B)�
Place an empty container with a minimum capacity of 50
oz�/ 1�5 liters under the cappuccino maker �
4� Wait for the coee lights to come on steadily�
Important! Danger of burns
Hot water containing acid ows from the cappuccino maker�
Avoid contact with splashes of water�
5� Press the
button and hold it down for at least 5
seconds to conrm that you have added the solution and
begin the descaling procedure� The light in the button
remains on steadily to indicate that the descaling program
has begun� The
light ashes telling you to turn the
steam dial to the l position�
6� Turn the steam dial a half turn anticlockwise to the I po-
sition� The descaler solution ows out of the cappuccino
maker into the underlying container�
The descale program automatically performs a series of
rinses and pauses to remove the limescale�
It is normal for several minutes of inactivity to elapse
between rinses�
After about 30 minutes, the water tank is empty and the
and
lights ash� Turn the steam dial clockwise as far as it
will go to the 0 position�
The appliance is now ready for rinsing through with clean
water�
7� Empty the container used to collect the descaler solution
and replace it empty under the cappuccino maker�
8� Remove the water tank, empty, rinse under running
water, ll with clean water and replace� The
light
4� Press the two red release buttons inwards and at the same
time pull the infuser outwards (g� 30)�
Important!
Clean the infuser without using dish soap as it could be
damaged�
5� Soak the infuser in water for about 5 minutes, then rinse
under the tap�
6� Clean coee residues from the support where the infuser
rests�
7� After cleaning, replace the infuser by sliding it onto the
internal support, then push the PUSH symbol fully in until
it clicks into place�
Please note :
If the infuser is dicult to insert, before insertion, adapt it to
the right size by pressing the two levers shown in the gure�
8� Once inserted, make sure the two red buttons have
snapped out�
8� Close the infuser door�
9� Replace the water tank�
DESCALE
Descale the appliance when the light on the control
panel ashes (g� 31)�
PUSH