Owner's Manual

16
ashes�
9� Turn the steam dial anticlockwise to the I position (g� 5)�
Hot water comes out of the spout�
10� When the water tank is completely empty, the
light
ashes�
11� Turn the dial to the 0 position� The
light goes
o�
Fill the water tank again and the machine is ready for use�
SETTING WATER HARDNESS
Descaling is necessary after a period of operation established
according to the water hardness set�
The machine is factory set for a hardness value of 4�
The machine can also be programmed according to the
hardness of the water supply in the various regions so that the
machine needs to be descaled less often�
Measuring water hardness
1� Remove the “TOTAL HARDNESS TEST” indicator paper
attached to this manual from its pack�
2� Immerse the paper completely in a glass of water for one
second�
3� Remove the paper from the water and shake lightly�
After about a minute, 1, 2, 3, or 4 red squares form,
depending on the hardness of the water� Each square
corresponds to one level�
Level 1
Level 2
Level3
Level 4
Set water hardness
1� Make sure the appliance is o (but connected to the
mains electricity supply and with the main switch in the I
position);
2� Press the
button and hold it down for at least
6 seconds� The
and lights come on
together;
3� Press the
button (on the left of the dial) to set
the actual water hardness as measured by the indicator
paper�
Level Level Level Level
1 234
4� Press the button (on the right of the dial) to
conrm the selection�
The machine is now reprogrammed with the new water
hardness setting�
TECHNICAL SPECIFICATION
Voltage: 120V ~60 HZ
Absorbed power: 1250W
Pressure: 15 bars
Water tank capacity: 1�8 liters max�
Size LxHxD: 238x340x430 mm
Cable length: 1�15 m
Weight: 9�1 kg
Coee beans container capacity: 250 g max�