Owner's Manual

18
LIGHT POSSIBLE CAUSE REMEDY
FLASHING
The infuser has not been replaced after
cleaning�
Insert the infuser as described in the section “Cleaning
the infuser”�
The inside of the appliance is very dirty� Clean the inside of the appliance thoroughly, as described
in the section ““Cleaning the inside of the coee maker”�
If the message is still displayed after cleaning, contact
customer services�
TROUBLESHOOTING
Below is a list of some of the possible malfunctions�
If the problem cannot be resolved as described, contact Customer Services�
PROBLEM POSSIBLE CAUSE REMEDY
The coee is not hot
The cups were not preheated� Warm the cups by rinsing them with hot water (Please note
you can use the hot water or rinse function)�
The infuser has cooled down because 2/3 minutes have
elapsed since the last coee was made�
Before making the coee, warm the infuser by pressing the
rinse button
�
The coee is thin or not
creamy enough
The coee is ground too coarsely� Turn the grinding adjustment dial one click anticlockwise
while the coee mill is in operation (g� 13)�
Continue one click at a time until coee delivery is
satisfactory� The eect is only visible after delivering two
coees (see the section: “Adjusting the coee mill” on
page 12)�
The coee is unsuitable� Use pre-ground coee for espresso coee makers�
The coee is delivered too
slowly or a drop at a time
The coee is ground too nely� Turn the grinding adjustment dial one click clockwise while
the coee mill is in operation (g� 10)� Continue one click at
a time until coee delivery is satisfactory� The eect is only
visible after delivering 2 coees (see the section: “Adjusting
the coee mill” on page 13)�
Coee does not come out of
one of the spouts
The spouts are blocked� Clean the spouts with a toothpick�
The frothed milk has large
bubbles
The milk is not cold enough or is not is not skim or 2%
milk�
You should ideally use skim or 2% milk at refrigerator
temperature (about 41°F / 5°C)�
If the result is still disappointing, try another brand of milk�
The milk is not frothed
Cappuccino maker is dirty� Clean as described in the section "Cleaning the cappuccino
maker after use" on page 13�
Steam delivery stops during
use
A safety device stops steam delivery after 3 minutes� Wait a few minutes, then activate the steam function
again�
The appliance does not
come on
It is not plugged into the mains socket� Plug into the mains socket�
The main switch (A8) is not turned on� Place the main switch in the I position (g� 3)�